A quantitative method for a priori evaluation of combustion reaction models
نویسندگان
چکیده
Combustion Theory and Modelling Publication details, including instructions for authors and subscription information: http://www.informaworld.com/smpp/title~content=t713665226 A quantitative method for a priori evaluation of combustion reaction models James C. Sutherland a; Philip J. Smith a; Jacqueline H. Chen b a Department of Chemical & Fuels Engineering, University of Utah, Salt Lake City, UT, USA b Combustion Research Facility, Sandia National Laboratories, Livermore, CA, USA
منابع مشابه
CFD Modeling Study of High Temperature and Low Oxygen Content Exhaust Gases Combustion Furnaces
This paper reports a CFD modeling study on the possibility of using high temperature and low oxygen content exhaust gases as oxidant for combustion in an industrial furnace by a written computer program. Under these conditions,the predicted results for the flow and heat transfer properties are compared with those under the several cases of conventional and highly preheated...
متن کاملEVALUATION OF SOLUTION COMBUSTION METHOD IN THE SYNTHESIS OF Fe-ZrSiO4 BASED CORAL PIGMENT
Abstract: Auto-ignited gel combustion process has been used for producing a red hematite-zircon based pigment. The combustible mixtures contained the metal nitrates and citric acid as oxidizers and fuel, respectively. Sodium silicate (water glass) was used as silica source for producing zircon phase. X-Ray Diffractometery, Electron Microscopy and Simultaneous Thermal Analysis were used for ...
متن کاملOptimization of fuel ratio in solution combustion method for fabrication of nickel aluminate spinel used in the esterification reaction
In this study, the solution combustion method as a simple, fast, and cost-effective method was utilizedfor the fabrication of spinel nickel aluminate as a stable material to use in the esterification reaction.The effect of fuel amount (urea) as an important parameter of the solution combustion method on thestructure, properties, and performance of the sample was evaluated. The...
متن کاملPreparation and Evaluation of NiFe204 and CuFe204 Nanoeatalysts by Combination of Sol- Gel Auto-Combustion Method and Irradiation Technique
The dried nitrate-urea gels exhibit the combination of autoicatatric combustion behavior and ultrasonic, whichcan be used to synthesize the nanocatalyst ferrite powders. Cu and Ni Unites nanocatalyst powders sithcomposition of Caned], and NiFe204 were synthesized by a sol-gel auto catalnic combustion process. Themolar ratio between metal ions and urea was 11.2. The sob gel process was done at 8...
متن کاملA Kinetic Investigation into the In Situ Combustion Reactions of Iranian Heavy Oil from Kuh-E-Mond Reservoir
An efficient design of in situ combustion depends on accurate kinetic modeling of the crude oil oxidation. The kinetic triplet of the oxidation reactions of a heavy oil sample was investigated. Once the kinetic triplet is known, the kinetic equation would be deconvolved. The crude oil sample was obtained from Kuh-E-Mond reservoir, located in the southwest of Iran. The samples were analyzed usin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2007