Studies on Sensitivity of Clock and Data Recovery Circuits to Power Supply Noise

نویسندگان

  • Khalil I. Mahmoud
  • J. Dhurga Devi
  • R. Rajasekar
  • P. V. Ramakrishna
چکیده

This paper deals with the study of the impact of power supply noise on the performance of CMOS Clock and Data Recovery (CDR) Circuits. The sensitivity of the various blocks of the dual loop CDR circuit to power supply noise is first studied and then it is demonstrated that insertion of suitable Low Dropout Regulators (LDOs) can enhance the performance of the CDR system with respect to power supply noise. Based on extensive simulations, it was observed that while the system can tolerate only about 20mV/10MHz noise on the power supply, incorporation of LDOs enables it to tolerate 200mV/10MHz noise without degradation in performance.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A new low power high reliability flip-flop robust against process variations

Low scaling technology makes a significant reduction in dimension and supply voltage, and lead to new challenges about power consumption such as increasing nodes sensitivity over radiation-induced soft errors in VLSI circuits. In this area, different design methods have been proposed to low power flip-flops and various research studies have been done to reach a suitable hardened flip-flops. In ...

متن کامل

Low Dropout Based Noise Minimization of Active Mode Power Gated Circuit

Power gating technique reduces leakage power in the circuit. However, power gating leads to large voltage fluctuation on the power rail during power gating mode to active mode due to the package inductance in the Printed Circuit Board. This voltage fluctuation may cause unwanted transitions in neighboring circuits. In this work, a power gating architecture is developed for minimizing power in a...

متن کامل

A Low Jitter 1.25GHz CMOS Analog PLL for Clock Recovery

 Conventional PLL design techniques used to implement CMOS GHz range clock recovery circuits typically suffer from significant power supply coupled noise in large integrated systems. This noise worsens the jitter of the PLL and degrades the system Bit-ErrorRate (BER). This paper describes an analog approach which applies fully differential current steering technique throughout the whole PLL sy...

متن کامل

A Minimal-Cost Inherent-Feedback Approach for Low-Power MRF-Based Logic Gates

The Markov random field (MRF) theory has been accepted as a highly effective framework for designing noise-tolerant nanometer digital VLSI circuits. In MRF-based design, proper feedback lines are used to control noise and keep the circuits in their valid states. However, this methodology has encountered two major problems that have limited the application of highly noise immune MRF-based circui...

متن کامل

High-performance and Low-power Clock Branch Sharing Pseudo-NMOS Level Converting Flip-flop

Multi-Supply voltage design using Cluster Voltage Scaling (CVS) is an effective way to reduce power consumption without performance degradation. One of the major issues in this method is performance and power overheads due to insertion of Level Converting Flip-Flops (LCFF) at the interface from low-supply to high-supply clusters to simultaneously perform latching and level conversion. In this p...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2011