A Design of an Experimental System for Trapping Pressure of Agricultural Gear Pump
نویسندگان
چکیده
The trapping phenomenon stems from the principle of gear pumps, and it affects directly the performance and life of gear pump. Reducing pressure in trapping area is an important aspect to improve working performance of gear pump, and how to test the pressure of trapping area is one of the most important problems. According to such requirements, an experimental system has been designed, and then relevant experiments are conducted on the designed experimental system. The experimental results indicate that the system can fulfill the requirements commendably.
منابع مشابه
Influence of Addendum Modification Factor on Root Stresses in Normal Contact Ratio Asymmetric Spur Gears
Tooth root crack is considered as one of the crucial causes of failure in the gearing system and it occurs at the tooth root due to an excessive bending stress developed in the root region. The modern power transmission gear drives demand high bending load capacity, increased contact load capacity, low weight, reduced noise and longer life. These subsequent conditions are satisfied by the aid o...
متن کاملOptimization Gear Oil Pump in Order to Energy Saving and Environmental Impact in a Diesel Engine
Oil pump in diesel engine has significant effect on energy consumption and environment pollution. In this paper, the modeling and simulation of a gear oil pump used in a diesel engine and its fluid flow analysis by a solver has been explained. Also the optimization and redesign of it has been discussed and then the outcomes have been compared with the experimental and previous results. The t...
متن کاملSimulation-based Vibration Sensor Placement for Centrifugal Pump Impeller Fault Detection
In this paper, a simulation-based method is proposed for optimal placement of vibration sensors for the purpose of fault detection in a centrifugal pump. The centrifugal pump is modeled to investigate the effect of vane tip fault on fluid flow patterns numerically. Pressure pulsations are investigated at different locations at the inner surface of the pump before and after the presence of the f...
متن کاملA Study of Precision Forging of Steel Spur Gears: Upper Bound Model and Experiments
Precision forging process is widely used for the production of spur gears due to its advantages such as improved strength and surface finish, little waste of materials and reduction in the machining time of the gear. An important aspect of precision forging process is the load required to perform the process successfully and design the forging tools. In this research, a new kinematically admiss...
متن کاملNumerical Investigation on the Effect of Mold Design on Shrinkage of Sand Casted Multistage BB3-6×6 Pump Casing (RESEARCH NOTE)
Design and manufacturing technology of high pressure multistage pumps which are commonly utilized in oil and gas industries, used to be imported from foreign companies. Due to international sanctions against I. R. Iran, it started to be designed and launched domestically. Nowadays all production lines including design, manufacturing and testing of these pumps have been performed by Iranian expe...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2009