The Wire Scanner System of the Final Focus Test Beam
نویسنده
چکیده
The system of wire scanners in use at the FFTB at SLAC is described. In addition to the scanners themselves, there is a discussion of detectors for the scattering from the wires, and of the procedure for handling beam spots of large aspect ratio. Submitted to NuclearInstrumentsad Methods in Physics Research -*Work Supported by US Department of Energy, contract DE-AC03-76SFO05 15.
منابع مشابه
The Wire Scanner at Bepcii
To monitor the beam profile in injector of BEPCII which is the upgrade project of Beijing Electron Positron Collider (BEPC). Several beam diagnostic and monitoring instruments are used. Wire scanner as a new diagnostic instrument was designed and manufactured to measure the beam profile at the end of linac in 2007.During the shutdown period of BEPCII we had installed the system at the end of li...
متن کاملMeasuring Micron Size Beams in the SLC Final Focus
A pair of high resolution wire scanners have been built and installed in the SLC final focus. The final focus optics uses a set of de-magnifying telescopes, and an ideal location for a beam size monitor is at one of the magnified image points of the interaction point. The image point chosen for these scanners is in the middle of a large bend magnet. The design beam spots here are about 2 micron...
متن کاملMeasurement of Small Electron Beam Spots
Measurements of transverse beam size are tremendously important to the performance of ee linear colliders. In this paper we review the traditional technologies used to make such measurements, such as pro le monitors and wire scanners, and the limitations on same. We then introduce a new tool for electron beam size measurement: Compton-scattered laser light, which may be used as an unbreakable \...
متن کاملThe Beam Observation System of the Isolde Facility
During the reconstruction of the ISOLDE on-line mass separator facility at CERN one of the goals was the development and implementation of an efficient and user friendly beam observation system. The pick-up devices used on the two mass separators and the beam lines are mainly Faraday cups, wire scanners and wire grids. Most of these items were specifically designed at ISOLDE, in particular, a l...
متن کاملNonlinear Analysis of a Flexible Beam Actuated by a Couple of Active SMA Wire Actuators
There are two different ways of using SMA wires as actuators for shape control of flexible structures; which can be either embedded within the composite laminate or externally attached to the structure. Since the actuator can be placed at different offset distances from the beam, external actuators produce more bending moment and, consequently, considerable shape changes with the same magnitude...
متن کامل