A Behavioral Average Model of Sepic Converters with Coupled Inductors
نویسندگان
چکیده
An average model of SEPIC converters with coupled inductors was developed and verified against cycle-by-cycle simulations. The model can be used as-is by any modern circuit simulator to run steady state (DC), large signal (Transient) and small signal (AC) analyses. The inductors coupling coefficient, incorporated as a parameter in the model, can be varied from zero to almost unity. Zero coupling coefficient represents the case of a SEPIC converter with uncoupled inductors.
منابع مشابه
A Unified Behavioral Average Model of Sepic Converters with Coupled Inductors
An average model of SEPIC converters with coupled or uncoupled inductors was developed and verified against cycle-by-cycle s i m u l a t i o n s . The model can be used as-is by any modern circuit simulator to run steady state (DC), large signal (transient) and small signal (AC) analyses. The leakage inductances were taken into account and treated separately from the mutual inductance. The prim...
متن کاملA Steady-state Analysis of PWM SEPIC Converter
The paper presents a unified steady-state analysis of PWM SEPIC converter with coupled inductors and separate inductors for both continuous and discontinuous conduction modes. The results of this simplified analysis allow to determine the operating point of converters and further the small-signal low-frequency parameters of linear model, and to design the converter too. The expressions of all s...
متن کاملDesign and Analysis of Multiphase Dc-dc Converters with Coupled Inductors
Design and Analysis of Multiphase DC-DC Converters with Coupled Inductors. (May 2007) Meng Shi, B.Eng., Shanghai Jiao Tong University, China Chair of Advisory Committee: Dr. Prasad Enjeti In this thesis, coupled inductors have been applied to multiphase DC-DC converters. Detailed analysis has been done to investigate the benefits of directly coupled inductors and inversely coupled inductors, co...
متن کاملAn Interleaved Configuration of Modified KY Converter with High Conversion Ratio for Renewable Energy Applications; Design, Analysis and Implementation
In this paper, a new high efficiency, high step-up, non-isolated, interleaved DC-DC converter for renewable energy applications is presented. In the suggested topology, two modified step-up KY converters are interleaved to obtain a high conversion ratio without the use of coupled inductors. In comparison with the conventional interleaved DC-DC converters such as boost, buck-boost, SEPIC, ZETA a...
متن کاملDesign Criteria for Sepic and Cuk Converters as Power Factor Preregulators in Discontinuous Conduction Mode
Power Factor Preregulators (PFP) have been used to improve input current waveform of off-line power supplies. There are two major approaches in implementing control circuits in PFP: the multiplier approach and the voltage-follower approach. The simplest one is the voltage-follower approach because the converter operates in discontinuous conduction mode (DCM), and only one loop control is requir...
متن کامل