Preparation of Highly Pure Vanadyl Sulfate from Sulfate Solutions Containing Impurities of Iron and Aluminum by Solvent Extraction Using EHEHPA

نویسندگان

  • Dan Li
  • Desheng Chen
  • Guozhi Zhang
  • Hongxin Zhao
  • Tao Qi
  • Weijing Wang
  • Lina Wang
  • Yahui Liu
چکیده

The preparation of highly pure vanadyl sulfate from sulfate solutions containing impurities of iron and aluminumwas investigated by solvent extraction with 2-ethylhexyl phosphoric acid mono-2-ethylhexyl ester (EHEHPA) and tri-n-butyl phosphate (TBP) as the phase modifier. The extraction and stripping conditions of vanadium (IV) and its separation from iron and aluminum were optimized. Under the optimal extraction conditions, the extraction of vanadium (IV) and iron were 68% and 53%, respectively, while only 2% aluminum was extracted in a single contact, suggesting good separation of vanadium (IV) from aluminum. Sulfuric acid solution was used for the stripping. Nearly 100% vanadium (IV) and 95% aluminum were stripped, while only 10% iron was stripped under the optimal stripping conditions in a single contact, suggesting good separation of vanadium (IV) from iron. After five stages of extraction and stripping, highly pure vanadyl sulfate containing 76.5 g/L V (IV) with the impurities of 12 mg/L Fe and 10 mg/L Al was obtained, which is suitable for the electrolyte of a vanadium redox flow battery. Organic solution was well regenerated after stripping by oxalic acid solution to remove the remaining iron. The mechanism of vanadium (IV) extraction using EHEHPA was also discussed based on the Fourier transform infrared spectroscopy (FT-IR) analysis.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Recovery of cobalt sulfate from spent lithium ion batteries by reductive leaching and solvent extraction with Cyanex-272

Cobalt sulfate was recovered from crushed and screened prismatic type spent lithium ion batteries (LIBs) containing 5~20 % Co, 5~7 % Li, 5~10 % Ni, 15% organic chemicals, and 7% plastics together with Cu, Al, Fe, and Mn. Cobalt was reductively leached from the -16 mesh fraction in 1 h by stirring with 2 M H2SO4 and 6 vol% H2O2, at 60 C and 300 rpm using a solid/liquid ratio of 100 g/L to give a...

متن کامل

Deep Desulfurization of Fuel Diesels Using Alkyl Sulfate and Nitrate Containing Imidazolium as Ionic Liquids

1-ethyl-3-methylimidazolium ethyl sulfate [Etmim][EtSO4 ],1, 3-dimethylimidazolium methyl sulfate [Mmim][MeSO4 ] and 1-octyl-3-methylimidazolium nitrate [Omim][NO3 ] ionic liquids have been used in thermal oxidative desulfurization of model fuel oils consisting of 500 ppm solutions of benzothiophene (BT) and dibenzothiophene (DBT) in dodecane. The efficiency of sulfur removal from BT and DBT so...

متن کامل

اثر وانادیل سولفات بر میزان مصرف محیط کشت توسط سلول های مرزه خوزستانی و بیوسنتز رزمارینیک اسید

Application of biotechnology for production and enhancing of important secondary metabolite by plant cell cultures and elicitors is one of the most noteworthy researches by scientists. This research was carried out with the aim of analysis the effects of Vanadyl Sulfate (abiotic elicitor) on media consumption by Satureja khuzistanica cells under suspension culture. Cells obtained after four sub...

متن کامل

Separation of Manganese and Iron from Reductive Leaching Liquor of Electric Arc Furnace Dust of Ferromanganese Production Units by Solvent Extraction

Electric arc furnace dust (EAFD) of ferromanganese production units, in the form of slurry, contains tar, alkalies, manganese, zinc, iron, silica, calcium, aluminum and other elements. A hydrometallurgical route based on solvent extraction technique was investigated for selective separation of manganese from the dust. Leaching of the EAFD resulted in an aqueous feed containing 4 g/L of manganes...

متن کامل

Preparation of Sodium Dodecyl Sulfate Modified Pyrrolidine-1-dithiocarboxylic acid Ammonium Coated Magnetite Nanoparticles for Magnetic Solid Phase Extraction of Pb(II) from Water Samples

This paper describes the development of a procedure for Pb(II) ions removal from various water samples after magnetic solid phase extraction (MNPs) by magnetite nanoparticles (Fe3O4 NPs) modified with sodium dodecyl sulfate (SDS) and pyrrolidine-1-dithiocarboxylic acid ammonium (PDTCAA). The synthesis of Fe3O4 NPs was certified by characterization techniques including field emission scanning el...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2017