Research on the Predict Method of Random Vibration Cumulative Fatigue Damage Life Based on the Finite Element Analysis
نویسندگان
چکیده
Aiming at most of the aviation products are facing the problem of fatigue fracture in vibration environment, we makes use of the testing result of a bracket, analysis for the structure with ANSYS-Workbench, predict the life of the bracket by different ways, and compared with the testing result. With the research on analysis methods, make an organic combination of simulation analysis and testing, Not only ensure the accuracy of simulation analysis and life predict, but also make a dynamic supervision of product life process, promote the application of finite element simulation analysis in engineering practice. Keywords—Random vibration, finite element simulation, fatigue, frequency domain.
منابع مشابه
Vibration reliability test and finite element analysis for flip chip solder joints
Vibration fatigue test and analysis methodology for flip chip solder joint fatigue life assessment have been developed by performing vibration tests with constant G-level and varying G-level input excitation. The linear cumulative damage analysis method (Miner’s rule) predicts non-conservative result for vibration fatigue life of flip chip solder joint. Finite element analysis (FEA) using a glo...
متن کاملLow Cycle Fatigue Simulation of Valve Bridge Region in Cylinder Head Based on Critical Plane Model
The reason of this study is low cycle failure of cast iron cylinder head during the E5 standard durability test. The goal of the present investigation is durability test simulation and low cycle fatigue life evaluation of cast iron cylinder head. With uncouple structural analysis, preloads, thermal and mechanical load and boundary conditions are prescribed to finite element model of the cylinde...
متن کاملPSD Analysis and Optimization of 2500hp Shale Gas Fracturing Truck Chassis Frame
The three-dimensional model of 2500hp shale gas fracturing truck chassis frame was established and the natural frequency of the frame was obtained by modal analysis. Taking the displacement power spectrum density of a typical road as a random excitation, the random vibration response of frame was obtained by PSD module of finite element analysis software ANSYS. Based on the results of PSD analy...
متن کاملFatigue Analysis and Optimization of Crankshaft of V8 Diesel Engine
The crankshaft is one of the most critically loaded components as it experiences cyclic loads in the form of bending and torsion during its service life. Its failure will cause serious damage to the engine so it’s important at the time of design to verify fatigue strength. More challenges in crankshaft design due to increasing vehicle payloads, lower weight requirement, higher efficiency and lo...
متن کاملSimulation and Experimental Study of Vibration and Noise of Pure Electric Bus Transmission based on Finite Element and Boundary Element Methods
Since the electric motor of pure electric vehicle replaced the engine, the "masking effect" disappears, and the problem of vibration and noise of the transmission becomes prominent. This is generated during the gear meshing and is transmitted to the housing through the shaft and bearing. Thereby, radiation noise of the housing are generated. The prediction and analysis...
متن کامل