Reduction of semiconductor laser diode phase and amplitude noise in interferometric fiber optic sensors.
نویسندگان
چکیده
An optical configuration employing two conventional Michelson interferometers and a fiber Fabry-Perot interferometer connected in parallel is used to demonstrate the principle of common mode rejection of both the amplitude and frequency noise of a semiconductor laser. Common mode noise rejection is maximized when the outputs of the two interferometers with matched path imbalance, fringe visibility and amplitude are differentially combined. One interferometer is used as a reference, and the other as a sensing interferometer. The fiber Fabry-Perot interferometer is used as the sensing interferometer and is demonstrated as a miniature acoustic sensing element.
منابع مشابه
Using of Broadened Asymmetric Waveguide Structure for 980nm Diode Laser
Laser diode beam divergence is the main parameter for beam shaping and fiber optic coupling. Increasing the waveguide layer thickness is the conventional method to decrease the beam divergence. In this paper, the broadened asymmetric waveguide is introduced to decrease the divergence without increasing the optical power. The asymmetric waveguide was used to shift the vertical optical field to n...
متن کاملFiber-optic gyroscopes based on polarization scrambling.
A novel fiber-optic gyroscope with a single-mode diode laser as the light source and two polarization scramblers as time-varying depolarizers is demonstrated. This arrangement reduces the nonreciprocal phase noise induced by the cross coupling between polarization modes in single-mode fibers. The experimental results show that a phase-noise reduction factor of 18 can be achieved.
متن کاملInterrogation of a fiber Fabry-Perot sensor by current modulation of a diode laser
February 2, 2008 Abstract— We present a method for remote interrogation of passive fiber Bragg grating Fabry-Perot resonators, employing current modulation of the diode laser source. With the presence of both RF amplitude and frequency modulation, it is a variant of the ultra-sensitive Pound-Drever-Hall laser frequency locking technique. We demonstrate that current modulation and interferometri...
متن کاملSome Useful Formulas for Analysis of Interferometric Noise
It is well known that phase noise fluctuations at the output of a semiconductor laser can produce intensity noise fluctuations upon transmission through a fiber-optic link due to interferometric phase-to-intensity conversion [1-4]. In a single-mode fiber link, the interferometric conversion occurs when multiple reflections occur between a pair of fiber interfaces (Figure 1). Even in the absence...
متن کاملElimination of pump-induced frequency jitter on fiber-laser frequency combs.
Optical frequency combs generated by femtosecond fiber lasers typically exhibit significant frequency noise that causes broad optical linewidths, particularly in the comb wings and in the carrier-envelope offset frequency (f(ceo)) signal. We show these broad linewidths are mainly a result of white amplitude noise on the pump diode laser that leads to a breathing-like motion of the comb about a ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- Applied optics
دوره 28 19 شماره
صفحات -
تاریخ انتشار 1989