Development behavior of liquid plasma produced by YAG laser
نویسندگان
چکیده
The laser induced plasma in liquid hasn’t been studied enough. In liquid, the laser induced plasma may be able to resolve the hazardous material called the environment material. Then, the plasma produced in liquid by the laser light is studied and the plasma development is observed by a streak camera. The ultra pure water or the ultra pure water with a melted NaCl is used as a test liquid. The liquid plasma is produced by the fundamental wave of YAG laser. When NaCl concentration is varied, the plasma development behavior is obserbed by streak camera. The liquid plasma develops backward. The plasma is produced from many seeds and It consists of a group of plasmas. However, the liquid plasma produced by second harmonic wave of YAG laser develops as a single plasma. The development mechanism is investigated from the growth rate of backward plasma. The backward plasma develops by breakdown wave and radiation supported shock wave.
منابع مشابه
Comparative study on EUV and debris emission from CO2 and Nd: YAG laser-produced tin plasmas
The emission characteristics of debris from laser-produced tin plasma were investigated for an extreme ultraviolet lithography (EUV) light source. The ions and droplets emitted from tin plasma produced by a CO2 laser or an Nd: YAG laser were detected with Faraday cups and quartz crystal micro-balance (QCM) detectors, respectively. A higher ion kinetic energy and a lower droplet emission were ob...
متن کاملPreparation and Characterization of ZnO Nanoparticles by Laser Ablation in NaOH Aqueous Solution
In the recent years, laser ablation in liquid has become an increasingly important technique for the fabrication of NPs. this paper reports our recent studies on the generation of ZnO NPs by ablation of metal targets in aqueous environments using Q-switch Nd-YAG laser (λ=532nm) immersed in NaOH (0.1M). The Surface topography studied by atomic force microscopy revealed wider size distributio...
متن کاملAngular distribution of debris from CO2 and YAG laser- produced tin plasmas
We investigated the angular dependence of atomic and ionic debris from CO2 and YAG laser-produced tin plasmas. Several diagnostic techniques were employed for this study including a Faraday cup, witness plates and subsequent x-ray photoelectron spectroscopic analysis, optical emission spectroscopy etc. It was found that the debris emission from the Nd:YAG laser-produced plasmas fell sharply fro...
متن کاملThe induced heat modeling using COMSOL software in nerve due to Nd: YAG laser irradiation
This article has no abstract.
متن کاملAnalysis, simulation, and experimental studies of YAG and CO2 laser- produced plasma for EUV lithography sources
Efficient laser systems are essential for the realization of high volume manufacturing in extreme ultraviolet lithography (EUVL). Solid-state Nd:YAG lasers usually have lower efficiency and source suppliers are alternatively investigating the use of high power CO2 laser systems. However, CO2 laser-produced plasmas (LPP) have specific characteristics and features that should be taken into accoun...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2004