Low Offset, High PSRR, CMOS Bandgap Voltage Reference
نویسندگان
چکیده
A CMOS Bandgap Voltage Reference (BVR) with the characteristics of low offset and high power-supply rejection ratio (PSRR) is presented. In order to reduce the effect of offset of operation amplifier (OPA), the voltage difference of base-emitter junctions of substrate bipolar transistors is maximized; meanwhile the factor of offset voltage could be minimized. The feedback loop constructed by proportional to absolute temperature (PTAT) current source and an OPA is employed to improve the PSRR. The circuit was designed and simulated in a standard 0.35-μm CMOS process, with a power supply of 3 volt. The relative accuracy is increased by 5 times compared with conventional circuit. PSRR of the circuit is ~108dB at low-frequency. Furthermore, temperature coefficient (TC) of 17ppm/°C over a wide temperature range of -40~115°C.The whole circuit including the OPA draws only 22 A from supply voltage. Silicon area is 0.037mm2. Streszczenie. Opisano pasmowy wzorzec napięcia w technologii CMOS charakteryzujący się małym pełzaniem zera i dużym współczynnikiem usuwania składowej zasilającej. Układ zaprojektowano w technologii 0.35m z napięciem zasilania 3V. (Pasmowy wzorzec napięcia z małym pełzaniem zera i dużym współczynnikiem PSRR)
منابع مشابه
High PSRR, Low Power Bandgap
This paper describes a new Bandgap Reference (BGR) architecture with low power consumption and high Power Supply Rejection Ratio (PSRR). Implemented in a 65nm CMOS technology, the circuit includes a pre-regulator, a current source and also digital validation for the bandgap voltage. The current consumption is below 4.9μA at 50oC, PSRR of -110dB@1kHz and -61.3dB@10MHz. The reference output volta...
متن کاملA 104μW EMI-resisting bandgap voltage reference achieving -20dB PSRR, and 5% DC shift under a 4dBm EMI level
This paper describes an electromagnetic interference (EMI)resisting Bandgap voltage reference. Its basic topology is a Kuijk Bandgap with a PMOS pass device and an active load, improved to generate a low voltage output (441.3mV) via substituting BJT by MOSFET while preserving a low temperature coefficient (TC). A double differential pair and a power-supply independent bias jointly enhance the E...
متن کاملA Low-Voltage High PSRR and High Precision CMOS Bandgap Reference
By adopting the technique of pre-regulator, a high PSRR and low temperature coefficient piecewise-linear bandgap reference (BGR) is designed for analog and mixed-signal application in this paper. The piecewise-linear BGR with pre-regulator, which is analyzed and simulated in SMIC 0.18μm CMOS process, has simple circuit architecture. Simulation results show that piecewise-linear BGR with pre-reg...
متن کاملA High PSRR Voltage Reference for High Efficiency Power Management Circuit of MEMS Energy Harvesters
A high power supply rejection ratio (PSRR) bandgap voltage reference (BGR) which is used in the signal processing circuit of energy harvesters is presented in this paper. The PSRR of the BGR is improved by adding a pre-regulating circuit and a low pass filter. The pre-regulating circuit mainly improves the BGR PSRR at low frequency and the low pass filter mainly improves the BGR PSRR at high fr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2012