Interferometric Processing of Palsar Wide-beam Scansar Data
نویسندگان
چکیده
Processing of ScanSAR data for interferometric applications requires careful attention to the phase and position accuracy to obtain interferometric products with high correlation and continuous phase across the bursts. We describe an interferometric processing system developed for ScanSAR data acquired by the ALOS PALSAR instrument able to produce differential interferometric products with 350 km swath width that are without visible phase discontinuities between ScanSAR beams.
منابع مشابه
First Results of the Alos Palsar Verification Processor
Among the several applications that will take advantage of the newly available data from the ALOS PALSAR instrument, considerable interest is in the peculiar features that derive from the penetration and polarimetric capabilities of the system. These capabilities, new for a single spaceborne sensor, need specific software tools for the processing of the different acquisition modes. This paper p...
متن کاملAlos Palsar Verification Processor
This paper presents a verification processor, developed under ESA contract, for the generation of polarimetric, interferometric and polarimetric-interferometric geocoded products derived from SAR data obtained from the ALOS PALSAR instrument. The processor, developed with a modular approach, contains the following main elements: Phase-preserving fine resolution processor; Phase-preserving ScanS...
متن کاملSAR interferometry using ALOS-2 PALSAR-2 data for the Mw 7.8 Gorkha, Nepal earthquake
The Advanced Land Observing Satellite-2 (ALOS-2, “DAICHI-2”) has been observing Nepal with the Phased Array type L-band Synthetic Aperture Radar-2 (PALSAR-2) in response to an emergency request from Sentinel Asia related to the Mw 7.8 Gorkha earthquake on April 25, 2015. PALSAR-2 successfully detected not only avalanches and local crustal displacements but also continental-scale deformation. Es...
متن کاملK&C Science Report – Phase 1 Synergetic Use of ALOS PALSAR, ENVISAT ASAR and Landsat TM/ETM+ Data for Land Cover and Change Mapping
Interferometric ALOS PALSAR Fine Beam Single/Dual, multi-temporal ENVISAT ASAR Alternating Polarization, and Landsat-5 TM/-7 ETM+ data are used for the generation of land cover and change maps. In synthesis, the product generation foresees two main steps: The first one consists in a rigorous data pre-processing, including interferometric processing (PALSAR), geometric / radiometric calibration ...
متن کاملBurst-mode and ScanSAR interferometry
ScanSAR interferometry is an attractive option for efficient topographic mapping of large areas and for monitoring of large-scale motions. Only ScanSAR interferometry made it possible to map almost the entire landmass of the earth in the 11-day Shuttle Radar Topography Mission. Also the operational satellites RADARSAT and ENVISAT offer ScanSAR imaging modes and thus allow for repeat-pass ScanSA...
متن کامل