Mixing at High Temperature and Density

نویسنده

  • Abhijit Bhattacharyya
چکیده

The temperature and density dependence of the ρ − ω mixing amplitude has been studied from a purely hadronic model. The in-medium baryon masses and chemical potentials have been obtained at the Mean Field (MF) Level and these results have been used to calculate the mixing amplitude. It has been observed that the mixing amplitude changes substantially at high temperature and density. Charge Symmetry Violation (CSV) is a very well established and interesting sphere of research. Though this field of research is quite old it is still quite challenging as the finer corrections from the experiments are still coming. The cross section for the process ee → ππ, in the ρ−ω resonance region, reveals an interference shoulder which results from the superposition of the narrow resonant ω and broad resonant ρ amplitudes [1]-[3]. Thus a G-parity violating process ω → ππ is observed. This observation motivates the study of ρ − ω mixing. Different authors have studied the ρ − ω mixing from different models and prescriptions [4]-[9]. In this article the temperature and density dependence of the mixing amplitude will be studied. The Email : [email protected]

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Large eddy simulation of propane combustion in a planar trapped vortex combustor

Propane combustion in a trapped vortex combustor (TVC) is characterized via large eddy simulation coupled with filtered mass density function. A computational algorithm based on high order finite difference (FD) schemes, is employed to solve the Eulerian filtered compressible Navier-Stokes equations. In contrast, a Lagrangian Monte-Carlo solver based on the filtered mass density function is inv...

متن کامل

An investigation on full annealing temperature and annealing twins’ Density in Fe-33Mn-3Si-2Al high-manganese steel

Twinning induced plasticity (TWIP) steels with high manganese percentage (17-35%), are mostly used in automotive bodies. Their microstructure at room temperature is austenitic, and due to the low stacking fault energy, major deformation mechanism in them is twinning inside austenite grains which leads to enhanced mechanical strength in the steel. Due to the important effect of heat treatment pr...

متن کامل

Effects of Cr2O3 on physical and mechanical properties of in-situ spinel containing castable

Increasing demands for cement, iron and steel industries for refractories with suitable workability in severe conditions (without any environmental risks), make the refractories’ researches to be an active area. Refractories containing Spinel has been developed with addition of chromia as a substitute in refractories using Magnesite - chromite. In this research, different amounts of Cr2O3 were ...

متن کامل

Liquid water oceans in ice giants

Aptly named, ice giants such as Uranus and Neptune contain significant amounts of water. While this water cannot be present near the cloud tops, it must be abundant in the deep interior. We investigate the likelihood of a liquid water ocean existing in the hydrogen-rich region between the cloud tops and deep interior. Starting from an assumed temperature at a given upper tropospheric pressure (...

متن کامل

Influence of High Temperatures on Flexural Strength of Foamed Concrete Containing Fly Ash and Polypropylene Fiber

In this study, the elevated temperature flexural strengths of lightweight foamed concrete (LFC) containing fly ash (FA) and polypropylene fiber (PF) was investigated experimentally and statistically. The variables included were the temperature degrees (in a range of 20 to 600°C), LFC densities of 600, 800, 1000, 1200 and 1400 kg/m3 and additive content. Two mixes were made by replacing 15% and ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 1998