Rapid Photo-assisted Forming Gas Anneal (fga) for High Quality Screen-printed Contacts for Silicon Solar Cells

Formation of low-cost high-quality contacts is the key to cost-effective silicon solar cells. Screen-printing is widely used in Industry because it is simple, low-cost and rapid. However, cost and throughput gains are attained at the expense of performance. IFill factors of most commercial cells are in the range of 0.68-75 for single crystalline material. This paper shows that a rapid 400°C/0.5-3 min photo-assisted anneal in a forming gas ambient can raise the fill factor (FF) of screen-printed (SP) single and multicrystalline (mc) Si cells from 0.70 to 0.77 and 0.76, respectively. Dark I-V analysis showed that this results from a decrease in series resistance by a factor of 2 to 4. Thus initial belt firing condiitions can be tailored (~ 700C) to first prevent the junction shunting, which generally results in high series resistance (Rs), and then the rapid photo-assisted anneal in forming gas ambient can be used to reduce the resistive losses for achieving high FF without much junction shunting. The lBIC analysis on multicrystalline silicon shows that a 30-second forming gas anneal in RTP not only reduces the glass frit at the silicon/silver interface but also enhances hydrogenation of bulk defects.