Use of GRA-Fuzzy and TOPSIS for Multi-Response Optimization in CNC End Milling
نویسنده
چکیده
04
منابع مشابه
A hybrid intuitionistic fuzzy multi-criteria group decision making approach for supplier selection
Due to the increasing competition of globalization, selection of the most appropriate supplier is one of the key factors for asupply chain management’s success. Due to conflicting evaluations and insufficient information about the criteria, Intuitionisticfuzzy sets (IFSs) considered as animpressive tool and utilized to specify the relative importance of the criteria. The aim of this paper is to...
متن کاملFeedrate optimization for ball-end milling of sculptured surfaces using fuzzy logic controller
Optimization of cutting parameters important in precision machining in regards to efficiency and surface integrity of the machined part. Usually productivity and precision in machining is limited by the forces emanating from the cutting process. Due to the inherent varying nature of the workpiece in terms of geometry and material composition, the peak cutting forces vary from point to point dur...
متن کاملIntegration of grey-based Taguchi technique in optimization of parameters process during the turning operation of 16MnCr5 steel
CNC turning is widely used as a manufacturing process through which unwanted material is removed to get the high degree of surface rough. In this research article, Taguchi technique was coupled with grey relation analysis (GRA) to optimize the turning parameters for simultaneous improvement of productivity, average surface roughness (Ra), and root mean square roughness (Rq).Taguchi technique L2...
متن کاملDEA-based Taguchi method for Optimization of CNC End milling Process parameters
In any machining operations, quality and productivity are the two important conflicting objectives. In order to give assurance for high productivity, some extent of quality has to be compromised. Similarly productivity will be decreased while the efforts are channelized to enhance quality. Therefore it is essential to optimize both quality and productivity simultaneously. Surface roughness and ...
متن کاملModeling and optimization of end milling parameters on aluminum 6061 alloy using GRA based Taguchi method coupled with PCA
Quality and productivity are two important aspects for manufacturing industries. Modeling and optimization is the best technique applied to find the best manufacturing conditions. This technique has been applied to investigate the optimized design of the cutting process in end milling for Al 6061 alloy in order to provide better surface finish as well as high Material Removal Rate (MRR). The cu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2012