Numerical Investigation of Instability of Complex Spatial Structures
نویسندگان
چکیده
Abstract: Consistent Imperfection Mode Method (CIMM) is a widely-used and effective numerical method to study the buckling capacity of spatial structure. CIMM used an “artificial” deformation instead of “artificial” load eccentricity to imitate the initial disturbance/imperfection for calculation of buckling load, and the basic mode obtained from linear buckling analysis could be used to simulate the distribution of imperfection. But in linear buckling analysis of certain complex spatial structures, the basic and first few modes usually reflect the local buckling of certain slim elements, and stability of complex structure depends on none of these local modes. Based on mode energy discrimination criterion, the improved CIMM is introduced. Improved CIMM includes following steps. 1) Normalization of all buckling modes. 2) Summarization of each mode of strain energy. 3) Discrimination of global modes with peak strain energy. 4) Based on first few global modes, CIMM could be used to calculate buckling loads respectively. 5) Choose the smallest buckling load as the buckling capacity of structure.
منابع مشابه
NUMERICAL AND EXPERIMENTAL INVESTIGATION OF WIND PRESSURE COEFFICIENTS ON SCALLOP DOME
The wind loads considerably influence lightweight spatial structures. An example of spatial structures is scallop domes that contain various configurations and forms and the wind impact on a scallop dome is more complex due to its additional curvature. In our work, the wind pressure coefficient (Cp ) on the scallop dome surface is studied numerically and experimentally. Firstly, the programming...
متن کاملNumerical Investigation on the effect of the internal water pressure and leakage force on the behavior of tunnel lining
There is a pressure tunnel as the type of structures, which is mainly used in the hydroelectric power industry and in order to design and construct these structures, there are many engineering challenges. One of these problems is the leakage around the tunnel and, consequently, erosion caused by excessive water pressure, and it will lead to instability and the destruction of pressure tunnels. T...
متن کاملA Numerical Investigation on the Unstable Flow in a Single Stage of an Axial Compressor
An unsteady two-dimensional finite-volume solver was developed based on Van Leer’s flux splitting algorithm in conjunction with “Monotonic Upstream Scheme for Conservation Laws (MUSCL)” limiters to improve the order of accuracy and the two-layer Baldwin-Lomax turbulence model was also implemented. Two test cases were prepared to validate the solver. The computed results were compared with the e...
متن کاملSize-dependent Vibration and Instability of Magneto-electro-elastic Nano-scale Pipes Containing an Internal Flow with Slip Boundary Condition
Size-dependent vibrational and instability behavior of fluid-conveying magneto-electro-elastic (MEE) tubular nano-beam subjected to magneto-electric potential and thermal field has been analyzed in this study. Considering the fluid-conveying nanotube as an Euler-Bernoulli beam, fluid-structure interaction (FSI) equations are derived by using non-classical constitutive relations for MEE material...
متن کاملNumerical investigation of variable uplift distribution at the level of landslide-induced acceleration at the concrete dam body crack position
The study of seismic behavior of concrete dams has been considered by many researchers due to the importance of dam safety during earthquakes. Because the destruction of these structures by earthquakes can have adverse economic and social effects. On the other hand, predicting the behavior of concrete dams during an earthquake is one of the most complex and difficult issues in structural dynami...
متن کامل