Impact of mineral fouling on hydraulic behavior of permeable reactive barriers.

This paper describes reactive transport simulations conducted to assess the impact of mineral fouling on the hydraulic behavior of continuous-wall permeable reactive barriers (PRBs) employing granular zero-valent iron (ZVI) in carbonate-rich alluvial aquifers. The reactive transport model included a geochemical algorithm for simulating corrosion and mineral precipitation reactions that have been observed in ZVI PRBs. Results of simulations show that porosity and hydraulic conductivity of the ZVI decrease over time and that flows are redistributed throughout the PRB in response to fouling of the pore space. Under typical conditions, only subtle changes occur within the first 10 years (i.e., duration of the current field experience record with PRBs), and the most significant changes do not occur until the PRB has operated for at least 30 years. However, changes can occur sooner (or later) if the rate at which mineral-forming ions are delivered to the PRB is higher (or lower) than that expected under typical conditions (i.e., due to higher/lower flow rate or inflowing ground water that has higher/lower ionic strength). When the PRB is more permeable than the aquifer, the median Darcy flux in the PRB does not change appreciably over time because the aquifer controls the rate of flow through the PRB. However, seepage velocities in the PRB increase, and residence times decrease, due to porosity reductions caused by accumulation of minerals in the pore space. When fouling becomes extensive, bypassing and reductions in flow rate in the PRB occur.