Automatic Gain Control in Wcdma Terminals
نویسنده
چکیده
This article gives a presentation of the Automatic Gain Control algorithm used in WCDMA (3rd generation mobile networks). The focus is on how the controller bandwidth influences settling times and modulation distortion. This will be investigated through simulation for two different channel cases.
منابع مشابه
Automatic Gain Control in High Speed WCDMA Terminals
In this study, it is investigated how different parameters influence 16QAM modulation. The focus is on how different parameters in the Automatic Gain Control algorithm influence raw bit error rates, but other parameters such as frequency error and misplaced decision levels are also investigated. The goal is not to develop optimal parameter configurations, but to gain some understanding on what ...
متن کاملDynamic Future Code Allocation Scheme for Dsch in Wcdma Systems
-Third generation wireless system is based on the WCDMA (Wide band Code Division Multiple Access) access technique. In this technique all the users share the same bandwidth simultaneously but with different codes. System transmits from base station to multiple user terminals or from user terminal to base station. WCDMA uses Orthogonal Variable Spreading Factor (OVSF) codes. Each user terminal d...
متن کاملPerformance Analysis of Downlink Time Switched Transmit Diversity in the WCDMA LCR-TDD System
A downlink transmit diversity scheme is proposed[1] for WCDMA low chip rate (1.28 Mcps) Time Division Duplex (LCR-TDD) systems. In the proposed Time Switched Transmit Diversity (TSTD) scheme, two spatially separated antennas are alternately used at a base station in order to transmit consecutive sub-frames on the downlink physical channels. The proposed TSTD scheme takes advantage of the frame ...
متن کاملWCDMA Common Pilot Power Control with Cost Function Minimization
This paper validates the feasibility of automating the setting of common pilot power in a WCDMA radio network. The pilot automation improves operability of the network and it is implemented with control software aiming for load balancing while also assuring pilot coverage. The pilot power of a cell is periodically updated with a gradient descent method that minimizes a cost function. The cost f...
متن کاملSystem Level Design of Multi-standard Receiver Using Reconfigurable RF Block
In this paper, we review the four receiver architectures and four methods for multi-standard receiver design. Propose reconfigurable RF block can be used for both low-IF and direct conversion architecture. Also, using reconfigurable mixer method, it can be operated at 2~6 GHz range for multistandard receiver. It consists of wideband mixer, filter, and automatic gain control amplifier and to get...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2004