Thin-Walled Double Side Freeform Component Milling Process with Paraffin Filling Method "2279
نویسندگان
چکیده
The machining of thin-walled double side freeform component has many challenges in terms of the geometrical complexity, high-requirement accuracy, and especially low stiffness. This paper surveys the filling method during the milling processes of thin-walled double side freeform component. Firstly, the DEFORM-3D was used to analyze and calculate the surface residual stress which provides a theoretical basis for parameters selection of the rough milling process, and the optimal milling parameters were obtained by the Taguchi method. Residual stress measurements have been carried out to verify the simulation results. The results show the difference between simulation and experimental data is less than 15%. Secondly, semi-finishing parameters and finishing process parameters were determined by equal error step length and step distance method. Thirdly, two machining experiments were conducted with and without paraffin filling, and the accuracy was measured by coordinate measurement machine. The results shown that the PV values are 25.16 μm and 20.34 μm for the concave and convex surface, and the corresponding RMS values are 13.75 μm and 11.93 μm in the first milling experiment. The PV values have improved to 8.53 μm and 7.12 μm, and RMS values have improved to 2.45 μm and 3.05 μm by the filled method applied.
منابع مشابه
NC Milling Process Planning for Thin-Walled Parts with Low Rigidity
To solve the problems that the low rigidity thin-walled part is easy to deform in NC milling process and some parts of the complex surface is difficult to process, this paper points out the measures for increasing accuracy of thin-walled NC machining process from the selection of material and blank, the choice of machine tool, the determination and optimization of the clamping method, the choic...
متن کاملStudy on residual stresses of thin-walled injection molding
The residual stresses of the thin-walled injection molding are investigated in this study. It was realized that the behavior of residual stresses in injection molding parts was affected by different process conditions such as melt temperature, mold temperature, packing pressure and filling time. The layer removal method was used to measure the residual stresses at a thin-walled test sample by a...
متن کاملDetecting Milling Deformation in 7075 Aluminum Alloy Aeronautical Monolithic Components Using the Quasi-Symmetric Machining Method
The deformation of aeronautical monolithic components due to CNC machining is a bottle-neck issue in the aviation industry. The residual stress releases and redistributes in the process of material removal, and the distortion of the monolithic component is generated. The traditional one-side machining method will produce oversize deformation. Based on the three-stage CNC machining method, the q...
متن کاملPrediction of Dynamic Milling Stability considering Time Variation of Deflection and Dynamic Characteristics in Thin-Walled Component Milling Process
متن کامل
Experimental Study on Double-Walled Copper and Carbon/Epoxy Composite Tubes under the Axial Loading
This paper investigates axial compression process of multi-layered tubes with circular cross-section under the axial loading in the quasi-static condition using experimental method. Some specimens are prepared in seven different groups, namely; empty carbon/epoxy composite tubes, solid carbon/epoxy composite rods, empty copper tubes, composite tubes with silicon sealant filler, concentrically s...
متن کامل