Creep and rupture behavior of peak-aged Mg-11Y-5Gd-2Zn-0.5Zr (wt.%)
نویسندگان
چکیده
Copyright and reuse: The Warwick Research Archive Portal (WRAP) makes the work of researchers of the University of Warwick available open access under the following conditions. Copyright © and all moral rights to the version of the paper presented here belong to the individual author(s) and/or other copyright owners. To the extent reasonable and practicable the material made available in WRAP has been checked for eligibility before being made available.
منابع مشابه
Creep Behavior of Basalt and Glass Fiber Reinforced Epoxy Composites
The creep behavior of basalt fiber reinforced epoxy (BFRE) and glass fiber reinforced epoxy (GFRE) composites was studied through tensile testing at high temperature. To study the effect of reinforcing epoxy, the micro glass powder (MGP) was added at various volume percentage into the epoxy resin in BFRE composites. The initial strain for all the specimens were evaluated and compared with each ...
متن کاملEvaluating the Effect of Ta/W Ratio on Microstructure and Stress Rupture Properties of Ni-Based Single Crystal Superalloy PWA1483
In this study, the effect of Ta/W ratio on the microstructure and stress rupture properties of Ni-based single crystal (SX) superalloy PWA1483 was investigated. For this purpose, single crystal (SX) superalloys with different Ta/W ratios (0.75, 1.0, 1.32 and 1.5 in wt.%) were fabricated. The alloys were directionally solidified by Bridgman method under the same solidification condition at withd...
متن کاملThe tensile and creep behavior of Mg–Zn Alloys with and without Y and Zr as ternary elements
Tensile–creep experiments were conducted in the temperature range 100–200 C and stress range 20–83 MPa for a series of magnesium–zinc–yttrium (Mg-Zn-Y) and mangnesium-zinc–zirconium (Mg-ZnZr) alloys ranging from 0 to 5.4 wt% Zn, 0 to 3 wt% Y, and 0 to 0.6 wt.% Zr. The greatest tensile– creep resistance was exhibited by an Mg–4.1Zn–0.2Y alloy. The room-temperature yield strength increased with i...
متن کاملThe microstructure , tensile properties , and creep behavior of Mg – Zn alloys containing 0 – 4 . 4 wt . % Zn
This paper describes the microstructure, tensile, and tensile–creep behavior of a series of Mg–Zn alloys ranging from 0 to 4.4 wt.% Zn. The microstructures consisted of equiaxed hexagonal-close-packed grains with fine precipitates preferentially located at grain boundaries. Some of the microstructures contained fine laths within the equiaxed grains. The finest grain sizes were observed for a Zn...
متن کاملA Creep Rupture Time Model for Anisotropic Creep-damage of Transversely-isotropic Materials
Anisotropic creep-damage modeling has become an increasingly important prediction technique in both the aerospace and industrial gas turbine industries. The introduction of tensorial damage mechanics formulations in modeling tertiary creep behavior has lead to improved predictions of the creep strain that develops due to anisotropic grain structures and the induced anisotropy that occurs with i...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2012