Ultrasonic Testing of Steel Castings
نویسنده
چکیده
Calibration and Reference Blocks ................................................................. 7 Longitudinal Wave Probes ............................................................................. 7 Transverse Wave Probes ............................................................................. 10 Measurement of Steel Thickness ................................................................. 12
منابع مشابه
Ultrasonic inspection of rough surface aluminium die castings
The condition of the surface through which a sound beam enters a material is an important factor in ultrasonic non-destructive testing(1). Detection of discontinuities such as cracks, voids and porosities in castings is greatly affected by the extent of roughness. Increased roughness reduces the transmitted energy of the sound beam and this, in turn, reduces the amplitude of the received signal...
متن کاملFast Signal-Averaging Unit for Ultrasonic Testing: Characterization of Materials Properties and SNR-Improvement for Coarse Grained Materials
The scattering of ultrasonic waves depends on the relation scatterer diameter to wavelength. Coarse grained materials and high frequency ultrasonic waves therefore ere exciting high scattering amplitudes. During pulseecho testing a backscattering signal is the result of superimposing all the single scattering processes in the sound beam for a given time of flight. Rectifying, digitizing and add...
متن کاملUltrasonic Inspection of Sub-Surface Defects In Aluminium Die- Castings
Non-destructive testing using ultrasonic measurement is used to ensure the quality of the die-casting products. The quality of a casting depends on the presence of discontinuities such as porosity and on the final metallurgical structure. Discontinuities occurring in the sub-surface of the cast structure mostly have irregular surfaces which scatter the ultrasound waves and make ultrasonic testi...
متن کاملWalker Parameter for Mean Stress Correction in Fatigue Testing of Al-7%Si-Mg Alloy Castings
In this study, performance of two existing Walker parameter estimation models has been investigated. Results show that those developed mainly for steel did not provide reasonable fits to experimental Walker parameters for fatigue data for Al-7%Si-Mg alloy castings in the literature. A strong relationship between the Walker parameter and the structural quality, quantified by the quality index, Q...
متن کاملAn innovative new pouring design for steel castings
An innovative new pouring design for steel castings" (2008). Retrospective Theses and Dissertations. Paper 14902.
متن کامل