Employing Alternative Number Systems to Reduce Power Dissipation in Portable Devices and High-Performance Systems
نویسندگان
چکیده
P ower dissipation has evolved into an instrumental design optimization objective due to the growing demand for portable electronics equipment as well as due to excessive heat generation in high-performance systems. In the former case , low-power techniques are employed to prolong battery life, while in the latter case, low-power techniques are required to mitigate the reliability problems that may arise. The dominant component of power dissipation for well-designed CMOS circuits is static power dissipation, given as [1]
منابع مشابه
Realization of a Low Power High Performance IC Design Technique for Wireless Portable Communication Devices used in Underground Mines
The demand for increasing speed and low power dissipation triggers numerous research efforts with the increasing demand of wireless portable communication systems in underground mines driven by batteries. Presence of highly flammable gases in underground mines prohibits the use of higher power dissipating electronic systems. Low power wireless portable communication devices can safeguard the li...
متن کاملBit Swapping Linear Feedback Shift Register For Low Power Application Using 130nm Complementary Metal Oxide Semiconductor Technology (TECHNICAL NOTE)
Bit swapping linear feedback shift register (BS-LFSR) is employed in a conventional linear feedback shirt register (LFSR) to reduce its power dissipation and enhance its performance. In this paper, an enhanced BS-LFSR for low power application is proposed. To achieve low power dissipation, the proposed BS-LFSR introduced the stacking technique to reduce leakage current. In addition, three diffe...
متن کاملA Comparison between SVC and STATCOM in Flicker Mitigation of Electric Arc Furnace using Practical Recorded Data
Electric arc furnace (EAF) is one of the largest loads in electric power systems. It is highly time varying and nonlinear. Its reactive power variations cause voltage fluctuations in nearby system which is known as flicker. On the other hand the nonlinear voltage-current characteristic causes strong voltage and current harmonics in EAF. To this end Flexible AC Transmission Systems (FACTS) techn...
متن کاملAn Experimental and Comparative Analysis of the Battery Charge Controllers in Off-Grid PV Systems
The study of the battery charge process as the only power storage agent in off-grid systems is of significant importance. The battery charge process has different modes, and the battery in these modes is dependent on the amount of charge. In order to charge the battery in off-grid systems, two charge controllers including Pulse Width Modulation (PWM) and Maximum Power Point Tracker (MPPT) are c...
متن کاملEvaluation of efficiency index of friction energy dissipation devices using endurance time method
Various methods have been presented to improve the performance of buildings against earthquakes. Friction damper device is one of the energy dissipation devices that appropriately absorbs and dissipates the input energy and decreases displacements. In this paper, the possibility of using endurance time method to determine the efficiency index and optimum slip load for these dampers was investig...
متن کامل