Optimization of amplifier placements in switch-based optical networks

نویسندگان

  • Ling Zhong
  • Byrav Ramamurthy
چکیده

Wavelength division multiplexing (WDM) offers a solution to the problem of exploiting the large bandwidth on optical links; it is the current favorite multiplexing technology for optical communication networks. Due to the high cost of an optical amplifier, it is desirable to strategically place the amplifiers throughout the network in a way that guarantees that all the signals are adequately amplified while minimizing the total number amplifiers being used. Previous studies all consider a star-based network. This paper demonstrates an original approach for solving the problem in switch-based WDM optical network assuming the traffic matrix is always the permutation of the nodes. First we formulate the problem by choosing typical permutations which can maximize traffic load on individual links; then a GA (Genetic Algorithm) is used to search for feasible amplifier placements. Finally, by setting up all the lightpaths without violating the power constaints we confirm the feasibility of the solution.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Design of Arrayed Waveguide Grating based Optical Switch for High Speed Optical Networks

This paper demonstrates the design of an Arrayed Waveguide Gratings (AWG) based optical switch. In the design both physical and network layer analysis is performed. The physical layer power and noise analysis is done to obtain Bit Error Rate (BER). This has been found that at the higher bit rates, BER is not affected with number of buffer modules. Network layer analysis is done to obtain perfor...

متن کامل

Optimization of Bistability in Nonlinear Chalcogenide Fiber Bragg Grating for All Optical Switch and Memory Applications

We solve the coupled mode equations governing the chalcogenide nonlinear fiber Bragg gratings (FBGs) numerically, and obtain the bistability characteristics. The characteristics of the chalcogenide nonlinear FBGs such as: switching threshold intensity, bistability interval and on-off switching ratio are studied. The effects of FBG length and its third order nonlinear refractive index on FBG cha...

متن کامل

A Class E Power Amplifier with Low Voltage Stress

A new output structure for class E power amplifier (PA) is proposed in this paper. A series LC resonator circuit, tuned near the second harmonic of the operating frequency is added to the output circuit. This resonator causes low impedance at the second harmonic. The output circuit is designed to shape the switch voltage of the class E amplifier and lower the voltage stress of the transistor. T...

متن کامل

Practical Integrated Design Strategies for Opaque and All-Optical DWDM Networks: Optimization Models and Solution Procedures

Dense wavelength division multiplexing (DWDM) opaque networks use expensive optical/electrical/optical (O/E/O) conversion at each end of a fiber link. Several technological advances have been used in an attempt to reduce the O/E/O conversion cost component: improved optical amplifiers using distributed Raman amplification allow signals to traverse longer distances without amplification and/or r...

متن کامل

Optimizing Amplifier Placements in a Multiwavelength Optical LAN/MAN: The Equally Powered-Wavelengths Case

Wavelength division multiplexing (WDM) provides the ability to utilize the enormous bandwidth offered by optical networks, using today’s electronics. WDM-based optical networks employing passive-star couplers have been proposed for deployment in local and metropolitan areas. Optical amplification is often required in such networks to compensate for the signal attenuation along the fiber links a...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2001