Numerical modelling of ductile fracture in blanking
نویسنده
چکیده
• A submitted manuscript is the author's version of the article upon submission and before peer-review. There can be important differences between the submitted version and the official published version of record. People interested in the research are advised to contact the author for the final version of the publication, or visit the DOI to the publisher's website. • The final author version and the galley proof are versions of the publication after peer review. • The final published version features the final layout of the paper including the volume, issue and page numbers.
منابع مشابه
Predicting the shape of blanked products: a ®nite element approach
Prediction of the properties of products of the blanking process is nowadays still mainly an empirical effort. The lack of fundamental knowledge of the process may cause lengthy process development, and obstructs process innovation. Consequently, a validated numerical model of the process would be of great value. In this paper, an elasto-plastic ®nite element model will be introduced, in which ...
متن کاملMeshfree simulations of thermo-mechanical ductile fracture
In this work, a meshfree method is used to simulate thermo-mechanical ductile fracture under finite deformation. A Galerkin meshfree formulation incorporating the Johnson-Cook damage model is implemented in numerical computations. We are interested in the simulation of thermomechanical effects on ductile fracture under large scale yielding. A rate form adiabatic split is proposed in the constit...
متن کاملPrediction of forming limit curves (FLD, MSFLD and FLSD) and necking time for SS304L sheet using finite element method and ductile fracture criteria
Forming limit curves are used as a parameter in finite element analysis to control the material's level of formability. In this research, forming limit diagram (FLD) of SS304L sheet was obtained by ABAQUSfinite element software. In practice, the experimental determination of a forming limit curve is a very time-consuming procedure which requires special and expensive equipment. Forming limit di...
متن کاملModelling of Failure in High Strength Steel Sheets
In this theses the high strength steel Docol 600DP and the ultra high strength steel Docol 1200M are studied. Constitutive laws and failure models are calibrated and verified by the use of experiments and numerical simulations. For the constitutive equations, an eight parameter high exponent yield surface has been adopted, representing the anisotropic behaviour, and a mixed isotropic-kinematic ...
متن کاملEffects of Carbides on Fatigue Characteristics of Austempered Ductile Iron
Crack initiation and growth behaviour of an austempered ductile iron (ADI) austenitised at 800C and austempered at 260C has been assessed under three point bend fatigue conditions. Initiation sites have been identified as carbides remaining from the as cast ductile iron due to insufficient austenisation. The number of carbides cracking on loading to stresses greater than 275 MPa is critical in ...
متن کامل