STORAGE RING CROSS SECTION MEASUREMENTS FOR ELECTRON IMPACT IONIZATION OF Fe7+
نویسندگان
چکیده
We have measured electron impact ionization for Fe from the ionization threshold up to 1200 eV. The measurements were performed using the TSR heavy ion storage ring. The ions were stored long enough prior to measurements to remove most metastables, resulting in a beam of 94% ground-level ions. Comparing with the previously recommended atomic data, we find that the Arnaud & Raymond cross section is up to about 40% larger than our measurement, with the largest discrepancies below about 400 eV. The cross section of Dere agrees to within 10%, which is about the magnitude of the experimental uncertainties. The remaining discrepancies between our measurement and the Dere calculations are likely due to shortcomings in the theoretical treatment of the excitation-autoionization contribution.
منابع مشابه
Storage ring cross section measurements for electron impact ionization of Fe8+
We have measured electron impact ionization (EII) for Fe forming Fe from below the ionization threshold to 1200 eV. These measurements were carried out at the TSR heavy ion storage ring. The objective of using a storage ring is to store the ion beam initially so that metastable levels decay, thereby allowing for measurements on a well-defined ground-level ion beam. In this case, however, some m...
متن کاملInfluence of long-lived metastable levels on the electron-impact single ionization of C2+
A joint theoretical and experimental investigation is made of the influence of long-lived metastable levels on the electron-impact single ionization of C2+. It is expected that our electron cyclotron resonance ion source produces a beam with 40% of the C2+ ions in the 1s22s2 S0 ground level and 60% in the 1s 22s2p P0,2 excited levels. The comparison of nonperturbative close-coupling calculation...
متن کاملAnalysis of electron impact ionization properties of methane
Published experimental photon and electron impact ionization cross sections of CH4 have been reviewed and analyzed. Absolute partial ionization oscillator strengths (fij) for CH4 , CH + 3 , CH + 2 , CH , H and H2 have been obtained. Electron impact ionization cross sections are recommended based on agreement between the oscillator strength values derived from photoionization and electron impact...
متن کاملTime-dependent close-coupling calculations for the electron-impact ionization of carbon and neon
A time-dependent close-coupling method is used to calculate the electron-impact ionization cross section for the outer 2p subshell of both carbon and neon atoms. The inner 1s and 2s subshells are treated using pseudopotentials, while interaction with the remaining 2p core electrons is handled in a configuration-average approximation. When the time-dependent ionization cross section for the 2p s...
متن کاملAbsolute electron-impact ionization cross section measurements using a magneto-optical trap.
We present a new method for measuring absolute total electron-impact ionization cross sections. The technique measures fractional loss rates from a magneto-optical trap due to electron-impact ionization. The method requires only relative measurements of the number of target atoms and therefore eliminates a major source of difficulty in previous experiments. We report total ionization cross sect...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2015