Effect of Remnant Crystallinity on Resistivity of Amorphous Alloys
نویسندگان
چکیده
It is shown for the Co-B series that changes in the temperature coefficient of resistivity, a , produced by a few percent of crystals within an amorphous matrix, are of the same order as changes of a with composition which have been reported in the literature, and interpreted in terms of physics of the amorphous state. Such low levels of crystalline fraction may escape notice by the standard methods of x-ray analysis or electron microscopy.
منابع مشابه
TRANSPORT AND MAGNETIC PROPERTIES OF (Fe100-xVx)75 P15C10 AMORPHOUS ALLOYS
(Fe100-xVx)75P15C10 (x = 0, 5, 10 and 15) amorphous alloys in the form of ribbon were prepared by the standard melt spinning technique and studied their transport and magnetic properties. The resistivity follows ‘Mooij correlation’ at low temperature (300 93) K. The Hall resistivity and the magnetoresistance (MR) were measured in an applied magnetic field up to 0.6T at room temperature (RT = 30...
متن کاملEffect of Ni on Amorphization of Ti-Cu-Ni Ternary alloys Prepared by Mechanical alloying
Amorphous alloys has been taken into consideration because of their unique properties and are nominated as the future engineering materials. In this research, the effect of Ni and milling time on amorphization process and thermal stability of Ti50Cu50-xNix(x=10, 15, 25 at%) alloy system were investigated. The evolution of amorphization during milling, thermal stability and subsequent heat treat...
متن کاملSide-jump effect in paramagnetic amorphous metals.
A systematic study of the resistivity (p), the Hall coefficients (R~), and the magnetic susceptibilities (y) of the Zr-based paramagnetic amorphous alloys suggests a self-consistent explanation for the frequently observed positive values of RH that is based on the side-jump effect. Measurements for g, RH, and p of (Zr064CuQ 36)& Al and g for (Zr05oNi050)& „Al alloys are presented. The odd behav...
متن کاملTHE EFFECT OF OPACIFIERS ON SURFACE ROUGHNESS OFCERAMIC GLAZES
Surface smoothness of ceramic glazes is always an important characteristic of ceramic glazes as a point of surface engineering studies. Surface roughness affects chemical resistivity, glossiness and stainabiliy of glazes. In fact, less surface roughness improves cleanability of the surface by the least usage amount of detergents. In this investigation, surface topography of two common opaque gl...
متن کاملPressure- and Temperature-Dependence of the Electrical Resistivity of Some Nonmagnetic d-electron Amorphous Alloys
Using the Ziman-formulation a model is derived which describes the pressure dependence of the electrical resistivity of d-electron amorphous alloys. It is shown how the volume dependence of the scattering-potential, electron-gas-properties and the Grüneisenparameter determine the P-dependence of a constant and a temperature dependent term in the resistivity. The absolute value of the resistivit...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2017