Structure of CdTe/ZnTe superlattices
نویسندگان
چکیده
The structure of CdTe/ZnTe superlattices has been analyzed through (J /28 x-ray diffraction, photoluminescence, and in situ reflection high-energy electron diffraction (RHEED) measurements. Samples are found to break away from CdxZn 1 _x Te buffer layers as a consequence of the 6% lattice mismatch in this system. However, defect densities in these superlattices are seen to drop dramatically away from the buffer layer interface, accounting for the intense photoluminescence and high-average strain fields seen in each of our samples. Observed variations in residual strains suggest that growth conditions play a role in forming misfit defects. This could explain discrepancies with calculated values of critical thickness based on models which neglect growth conditions. Photoluminescence spectra reveal that layer-to-layer growth proceeded with single monolayer uniformity, suggesting highly reproducible growth. Our results give hope for relatively defect-free Cdx Zn1 _ x Te/Cdy Zn1 _ Y Te superlattices with the potential for applications to optoelectronics offered by intense visible light emitters.
منابع مشابه
Type-II CdSe/CdTe/ZnTe (core-shell-shell) quantum dots with cascade band edges: the separation of electron (at CdSe) and hole (at ZnTe) by the CdTe layer.
The rational design and synthesis of CdSe/CdTe/ZnTe (core-shell-shell) type-II quantum dots are reported. Their photophysical properties are investigated via the interband CdSe-->ZnTe emission and its associated relaxation dynamics. In comparison to the strong CdSe (core only) emission (lambda(max) approximately 550 nm, Phi(f) approximately 0.28), a moderate CdSe-->CdTe emission (lambda(max) ap...
متن کاملAnalysis of Cu Diffusion in ZnTe-Based Contacts for Thin-Film CdS/CdTe Solar Cells
Ohmic contacts to thin-film CdS/CdTe photovoltaic devices have been formed using a two-layer contact interface of undoped ZnTe (ZnTe) and Cu-doped ZnTe (ZnTe:Cu), followed by Ni or Ti as an outer metallization. Secondary ion mass spectroscopy (SIMS) is used to study Cu diffusion within this back-contact structure, and also, to monitor Cu diffusion from the contact into the CdTe. When Ni metalli...
متن کاملInterface Structure and Surface Polarity in CdTe/ZnTe/(112)Si Hetero-Epitaxial System
Tellurium adsorption on clean (112) Si surfaces obey a second order kinetic law. The adsorbed Te ad-atoms are highly immobile. Activation energies of adsorption and desorption were measured by isothermal desorption rates. A surface bond energy model was used to calculate the total energy for Te chemisorption on (111) terraces. This model yields a Si-Te bond energy of about 3.46 eV. As-Te bond e...
متن کاملComparison of Normal and Inverted Band Structure HgTe/CdTe Superlattices for Very Long Wavelength Infrared Detectors
The type III band alignment of HgTe/CdTe superlattices leads to the interesting possibility of achieving very long wavelength infrared (VLWIR) (15 μm and longer) cutoff wavelengths with either normal (HgTe layer thickness less than about 70 Å for CdTe layer thickness of 50 Å) or inverted (HgTe thickness greater than about 70 Å) band structures. The inverted band structure superlattices promise ...
متن کاملRaman spectra of CdTe/ZnTe self-assembled quantum dots
In this paper we present Raman scattering and photoluminescence spectra measured on CdTe/ZnTe self assembled quantum dots. The photoluminescence spectrum has shown two main emission peaks, both connected with existing of quantum dots. One presents direct deexcitation to ground state and the other is optical phonon (ω = 207.3 cm−1)-assisted deexcitation. The registered multiphonon emission proce...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2000