Optical imaging using binary sensors.

Differential Binary Encoding Method for Calibrating Image Sensors Based on IOFBs

Image transmission using incoherent optical fiber bundles (IOFBs) requires prior calibration to obtain the spatial in-out fiber correspondence necessary to reconstruct the image captured by the pseudo-sensor. This information is recorded in a Look-Up Table called the Reconstruction Table (RT), used later for reordering the fiber positions and reconstructing the original image. This paper presen...

Weight Measurements by Using Simple Optical-Fiber Sensors (RESEARCH NOTE)

The use of different optical-fiber sensors for weighing measurements is Abstract described. By using three different mechanical stressing mechanisms, the operation of the fiber-to-fiber transducer systems are tested and the results are presented. Parameters such as sensitivity, hysteresis, resolution, and dynamic range are measured. A comparison of the results has shown that the sensor system m...

OPTICAL PROPERTIES OF CO-EVAPORATED THIN FILMS OF BINARY Bi 0-Te 0 AND Bi 0 -V 0 SYSTEMS

Thin films of binary Bi 0 -TeO and Bi 0 -V 0 systems were prepared by the thermal co-evaporation technique in a vacuum at room temperature. The optical absorption edge of these systems are studied in the wavelength of 200-800 nm using a PERKIN-ELMER uv/Vis spectrophotometer. It is found that the value of n=3/2 in the Davis-Mott equation is best fitted for the fundamental absorption edge f...

Determination of experimental Tumor Volume of a mouse using optical imaging system in different processing stages

Noise Equivalent Power Optimization of Graphene- Superconductor Optical Sensors in the Current Bias Mode

In this paper, the noise equivalent power (NEP) of an optical sensor based ongraphene-superconductor junctions in the constant current mode of operation has beencalculated. Furthermore, the necessary investigations to optimize the device noise withrespect to various parameters such as the operating temperature, magnetic field, deviceresistance, voltage and current bias have been presented. By s...