Study of changes in composition and EELS ionization edges upon Ni4Ti3 precipitation in a NiTi alloy.

نویسندگان

  • Zhiqing Yang
  • Dominique Schryvers
چکیده

Concentration gradients surrounding Ni4Ti3 precipitates grown by appropriate annealing in a Ni51Ti49 B2 austenite matrix are investigated by electron energy loss spectroscopy (EELS) and energy filtered transmission electron microscopy (EFTEM). Concentration gradients of approximately 1.0-2.0 at.% in Ni within the surrounding B2 matrix can be detected by both EELS and EFTEM, revealing a Ni depleted zone in the matrix. Besides the concentration gradients, the EELS integrated cross-section of the Ni L(2,3) edges for the Ni-depleted region increased slightly, when compared with a matrix region away from the precipitate and not depleted in Ni.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Role of Severe Plastic Deformation in Suppressing Formation of R Phase and Ni4Ti3 Precipitate of NiTi Shape Memory Alloy

Microstructural evolution of NiTi shape memory alloy (SMA) with a nominal composition of Ni50.9Ti49.1 (at %) is investigated on the basis of heat treatment and severe plastic deformation (SPD). As for as-rolled NiTi SMA samples subjected to aging, plenty of R phases appear in the austenite matrix. In terms of as-rolled NiTi SMA samples undergoing solution treatment and aging, Ni4Ti3 precipitate...

متن کامل

Dissimilar laser welding of NiTi shape memory alloy to austenitic stainless steel archwires

In this research, dissimilar welding of NiTi shape memory alloy to AISI 304 austenitic stainless steel Archwires was investigated. For this purpose, common straight orthodontic archwire with rectangular cross-section and dimensions of (0.635 × 0.432 mm) were selected and the laser welding technique was used to connect the wires. The microstructure, chemical composition and phasesin the weld zon...

متن کامل

Dissimilar laser welding of NiTi shape memory alloy to austenitic stainless steel archwires

In this research, dissimilar welding of NiTi shape memory alloy to AISI 304 austenitic stainless steel Archwires was investigated. For this purpose, common straight orthodontic archwire with rectangular cross-section and dimensions of (0.635 × 0.432 mm) were selected and the laser welding technique was used to connect the wires. The microstructure, chemical composition and phasesin the weld zon...

متن کامل

Surface Activation of NiTi Alloy by Using Electrochemical Process for Biomimetic Deposition of Hydroxyapatite Coating (TECHNICAL NOTE)

Electrochemical depositions of calcium phosphate (Ca-P) film on NiTi alloy in concentrated simulated body flood (SBF×5) were carried out by cathodic polarization. The Ca-P layer was successfully deposited on Ni-Ti alloy substrate under 10mA/cm2 current density for 2 hours at room temperature. Then, in order to investigate the bioactivity of the pre-calcified samples, they were immersed in SBF f...

متن کامل

Phase Changes in Ni-ti under Laser Shock Loading

Near-equiatomic Ni-Ti, known for its shape memory behavior, can decompose to martensitic phases and/or second phase compounds. This phase competition is investigated in NixTi100-x (49<x<55) in as-quenched (AQ) and shock-loaded states. Dynamic loading was done with direct drive laser pulses of nanosecond duration; shocked samples were recovered for analysis. Unexpectedly, the lowest-Ni alloy (x ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Micron

دوره 37 5  شماره 

صفحات  -

تاریخ انتشار 2006