Fast Method for Searching Image Quality Inspection Procedures
نویسندگان
چکیده
Fast Method for Searching Image Quality Inspection Procedures Kousuke HARA Minoru AKUTSU Tetsuya OOTANI and Takashi OMORI †Instrument and Control Research Center, Yokogawa Electric Corporation 2-9-32 Nakacho Musashino-shi, Tokyo, 180-8750 Japan ‡Graduate School of Engineering, Hokkaido University 13-8, Kita-ku, Sapporo, 060-8628 Japan E-mail: †{Kousuke.Hara, Minoru.Akutsu, Tetsuya.Ootani}@jp.yokogawa.com, ‡[email protected] Abstract The production of flat panel displays and image sensors has been increasing rapidly by the recent diversification of their uses. For that reason, in the defect inspection of those image devices, the automation of image inspection has proceeded. However, it was difficult to make general procedures of image processing, because there were various defects. Therefore, engineering cost increases. This paper describes a searching system for image processing procedures and parameters. In particular, we propose the fast method using the searching results for similar defects. Keyword Vision Expert System, Image Quality Inspection, Simulated Annealing
منابع مشابه
Artifact reduction techniques in Cone Beam Computed Tomography (CBCT) imaging modality
Introduction: Cone beam computed tomography (CBCT) was introduced and became more common based on its low cost, fast image procedure rate and low radiation dose compared to CT. This imaging modality improved diagnostic and treatment-planning procedures by providing three-dimensional information with greatly reduced level of radiation dose compared to 2D dental imaging modalitie...
متن کاملFast Reconstruction of CFRP X-ray Images based on a Neural Network Filtered Backprojection Approach
X-ray inspection of Carbon Fiber Reinforced Polymer (CFRP) is time consuming. With classical reconstruction methods, many projections of the object from different orientations are required to obtain high quality reconstructions of the interior fiber composition. In this work, we propose to reconstruct the interior of the CFRP samples with a Neural Network Filtered Backprojection (NN-FBP) method...
متن کاملRobust Parameter Design of Derivative Optimization Methods for Image Acquisition Using a Color Mixer
A tuning method was proposed for automatic lighting (auto-lighting) algorithms derived from the steepest descent and conjugate gradient methods. The auto-lighting algorithms maximize the image quality of industrial machine vision by adjusting multiple-color light emitting diodes (LEDs)—usually called color mixers. Searching for the driving condition for achieving maximum sharpness influences im...
متن کاملFast System Matrix Calculation in CT Iterative Reconstruction
Introduction: Iterative reconstruction techniques provide better image quality and have the potential for reconstructions with lower imaging dose than classical methods in computed tomography (CT). However, the computational speed is major concern for these iterative techniques. The system matrix calculation during the forward- and back projection is one of the most time- cons...
متن کاملQuality Analysis of Indian Basmati Rice Grains Using Digital Image Processing- A Review
Quality of rice is defined from its physical and chemical characteristics. Quality of grains is required for protecting the consumers from substandard products because the samples of food materials are subjected to adulteration. This paper provides a solution to the problem of the rice industry for quality analysis. Computer Vision based Inspection provides one alternative for fast, accurate, c...
متن کامل