Conversion, shrinkage, water sorption, flexural strength and modulus of re-mineralizing dental composites.

نویسندگان

  • A Aljabo
  • W Xia
  • S Liaqat
  • M A Khan
  • J C Knowles
  • P Ashley
  • A M Young
چکیده

OBJECTIVES Cure, volumetric changes and mechanical properties were assessed for new dental composites containing chlorhexidine (CHX) and reactive calcium phosphate-containing (CaP) to reduce recurrent caries. METHODS 20wt.% of light curable urethane dimethacrylate based liquid was mixed with 80wt.% glass filler containing 10wt.% CHX and 0-40wt.% CaP. Conversion versus depth with 20 or 40s light exposure was assessed by FTIR. Solidification depth and polymerization shrinkage were determined using ISO 4049 and 17304, respectively. Subsequent volume expansion and biaxial flexural strength and modulus change upon water immersion were determined over 4 weeks. Hydroxyapatite precipitation in simulated body fluid was assessed at 1 week. RESULTS Conversion decreased linearly with both depth and CaP content. Average solidification depths were 4.5, 3.9, 3.3, 2.9 and 5.0 with 0, 10, 20, and 40% CaP and a commercial composite, Z250, respectively. Conversions at these depths were 53±2% for experimental materials but with Z250 only 32%. With Z250 more than 50% conversion was achieved only below 1.1mm. Shrinkage was 3% and 2.5% for experimental materials and Z250, respectively. Early water sorption increased linearly, whilst strength and modulus decreased exponentially to final values when plotted versus square root of time. Maximum volumetric expansion increased linearly with CaP rise and balanced shrinkage at 10-20wt.% CaP. Strength and modulus for Z250 decreased from 191 to 158MPa and 3.2 to 2.5GPa. Experimental composites initial strength and modulus decreased linearly from 169 to 139MPa and 5.8 to 3.8GPa with increasing CaP. Extrapolated final values decreased from 156 to 84MPa and 4.1 to 1.7GPa. All materials containing CaP promoted hydroxyapatite precipitation. SIGNIFICANCE The lower surface of composite restorations should both be solid and have greater than 50% conversion. The results, therefore, suggest the experimental composite may be placed in much thicker layers than Z250 and have reduced unbounded cytotoxic monomer. Experimental materials with 10-20wt.% additionally have volumetric expansion to compensate shrinkage, antibacterial and re-mineralizing components and competitive mechanical properties.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Monomer conversion, dimensional stability, strength, modulus, surface apatite precipitation and wear of novel, reactive calcium phosphate and polylysine-containing dental composites

PURPOSE The aim was to assess monomer conversion, dimensional stability, flexural strength / modulus, surface apatite precipitation and wear of mono / tri calcium phosphate (CaP) and polylysine (PLS)-containing dental composites. These were formulated using a new, high molecular weight, fluid monomer phase that requires no polymerisation activator. MATERIALS AND METHODS Urethane and Polypropy...

متن کامل

Thiol-Ene-Methacrylates as Dental Restorative Materials

Thiol-ene systems demonstrate numerous advantageous polymerization properties in regards to rapid curing, high conversion, minimal oxygen inhibition, and reduced shrinkage stress. However, one of the drawbacks of thiol-ene systems is that commercially available monomers are not able to achieve the mechanical properties required for use as dental restorative materials. Methacrylate systems on th...

متن کامل

Poly(propylene glycol) and urethane dimethacrylates improve conversion of dental composites and reveal complexity of cytocompatibility testing.

OBJECTIVES To determine the effects of various monomers on conversion and cytocompatibility of dental composites and to improve these properties without detrimentally affecting mechanical properties, depth of cure and shrinkage. METHODS Composites containing urethane dimethacrylate (UDMA) or bisphenol A glycidyl methacrylate (Bis-GMA) with poly(propylene glycol) dimethacrylate (PPGDMA) or tri...

متن کامل

Polymerization shrinkage, flexural and compression properties of low-shrinkage dental resin composites.

This study evaluated the polymerization shrinkage, flexural and compressive properties of low-shrinkage resin composites. For the study, four methacrylate-based and one silorane-based resin composites were light cured using three different light-curing units (LCUs) and their polymerization shrinkage, flexural (strength (FS) and modulus (FM)) and compressive (strength (CS) and modulus (CM)) prop...

متن کامل

Dental Composites with Calcium / Strontium Phosphates and Polylysine

PURPOSE This study developed light cured dental composites with added monocalcium phosphate monohydrate (MCPM), tristrontium phosphate (TSrP) and antimicrobial polylysine (PLS). The aim was to produce composites that have enhanced water sorption induced expansion, can promote apatite precipitation and release polylysine. MATERIALS AND METHODS Experimental composite formulations consisted of l...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:
  • Dental materials : official publication of the Academy of Dental Materials

دوره 31 11  شماره 

صفحات  -

تاریخ انتشار 2015