Weakly nonlinear subcritical instability of visco-elastic Poiseuille flow

نویسندگان

  • Bernard Meulenbroek
  • Cornelis Storm
  • Alexander N. Morozov
  • Wim van Saarloos
چکیده

It is well known that the Poiseuille flow of a visco-elastic polymer fluid between plates or through a tube is linearly stable in the zero Reynolds number limit, although the stability is weak for large Weissenberg numbers (Wi). In this paper, we argue that recent experimental and theoretical work on the instability of visco-elastic fluids in Taylor–Couette cells and numerical work on channel flows suggest a scenario in which Poiseuille flow of visco-elastic polymer fluids exhibits a nonlinear “subcritical” instability due to normal stress effects, with a threshold which decreases for increasing Weissenberg number. This proposal is confirmed by an explicit weakly nonlinear stability analysis for Poiseuille flow of an UCM fluid. Our analysis yields explicit predictions for the critical amplitude of velocity perturbations beyond which the flow is nonlinearly unstable, and for the wavelength of the mode whose critical amplitude is smallest. The nonlinear instability sets in quite abruptly at Weissenberg numbers around 4 in the planar case and about 5.2 in the cylindrical case, so that for Weissenberg numbers somewhat larger than these values perturbations of the order of a few percentage in the wall shear stress suffice to make the flow unstable. We have suggested elsewhere that this nonlinear instability could be an important intrinsic route to melt fracture and that preliminary experiments are both qualitatively and quantitatively in good agreement with these predictions. © 2004 Elsevier B.V. All rights reserved.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Intrinsic route to melt fracture in polymer extrusion: a weakly nonlinear subcritical instability of viscoelastic poiseuille flow.

As is well known, the extrusion rate of polymers from a cylindrical tube or slit (a "die") is in practice limited by the appearance of "melt fracture" instabilities which give rise to unwanted distortions or even fracture of the extrudate. We present the results of a weakly nonlinear analysis which gives evidence for an intrinsic generic route to melt fracture via a weakly nonlinear subcritical...

متن کامل

An introductory essay on subcritical instabilities and the transition to turbulence in visco-elastic parallel shear flows

This paper is an pedagogical essay on the scenario of the instabilities and the transition to turbulence in visco-elastic polymer flows. When polymers are long, they get easily stretched by the shear present in flows, and the viscosity of the solution or melt is large. As a result, inertial effects are usually negligible as the Reynolds numbers are small but the fluid is strongly nonNewtonian d...

متن کامل

A new numerical framework to simulate viscoelastic free-surface flows with the finite- volume method

A new method for the simulation of 2D viscoelastic flow is presented. Numerical stability is obtained by the logarithmic-conformation change of variable, and a fully-implicit pure-streamfunction flow formulation, without use of any artificial diffusion. As opposed to other simulation results, our calculations predict a hydrodynamic instability in the 4:1 contraction geometry at a Weissenberg nu...

متن کامل

Nonlinear Flow-Induced Flutter Instability of Double CNTs Using Reddy Beam Theory

In this study, nonlocal nonlinear instability and the vibration of a double carbon nanotube (CNT) system have been investigated. The Visco-Pasternak model is used to simulate the elastic medium between nanotubes, on which the effect of the spring, shear and damping of the elastic medium is considered. Both of the CNTs convey a viscose fluid and a uniform longitudinal magnetic field is applied t...

متن کامل

Experimental evidence for an intrinsic route to polymer melt fracture phenomena: a nonlinear instability of viscoelastic Poiseuille flow.

The production rate of polymer fibers by extrusion is usually limited by the appearance of a series of instabilities ("melt fracture") that lead to unwanted undulations of the surface. We present both qualitative and quantitative experimental evidence that-in addition to previously known polymer-specific scenarios-there is an intrinsic route towards melt fracture type phenomena: a nonlinear ("s...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2004