ON THE FINE STRUCTURE SPLITTING OF THE 3p3d
نویسندگان
چکیده
We study UV spectra obtained with the SO82-B slit spectrograph on board SKYLAB to estimate the fine structure splitting of the Cl-like 3p3d D5/2 and 3p 3d D7/2 levels of Fe X. The splitting is of interest because the Zeeman effect mixes these levels, producing a “magnetically induced transition” (MIT) from 3p3d D7/2 to 3p 5 P3/2 for modest magnetic field strengths characteristic of the active solar corona. We estimate the splitting using the Ritz combination formula applied to two lines in the UV region of the spectrum close to 1603.2 Å, which decay from the level 3p(D)3d G7/2 to these two lower levels. The MIT and accompanying spin-forbidden transition lie near 257 Å. By careful inspection of a deep exposure obtained with the S082B instrument we derive a splitting of ∼ < 7 ± 3 cm. The upper limit arises because of a degeneracy between the effects of non-thermal line broadening and fine-structure splitting for small values of the latter parameter. Although the data were recorded on photographic film, we solved for optimal values of line width and splitting of 8.3± 0.9 and 3.6± 2.7 cm.
منابع مشابه
Investigating Different Methods of Closed Shell Pistachios Splitting and Effects of Freezing Prior to Drying on Shell Splitting Percentage
In this study, different methods for shell splitting and the effect of freezing prior to drying on shell splitting percentage of pistachio were investigated. A completely randomized design was used to investigate the effects of different freezing temperatures (0, -6, -12 and -18°C), different drying temperatures (80, 90 and 100°C) and different cultivars (Akbari and Kalehghouchi) on shell split...
متن کاملDeveloping Very Fine Nanopearlitic Structure in a High Carbon Steel Wire before Drawing
The effects of steel wire patenting process parameters on very fine interlamellar spacing in the pearlitic steel wire were investigated and the optimized condition of the process was achieved. In this work, the initial nanopearlitic structure was obtained in a 0.72 wt% carbon steel wire before the wire drawing process. The results were the minimum interlamellar spacing of 35 nm and maximum ulti...
متن کاملA new 2D block ordering system for wavelet-based multi-resolution up-scaling
A complete and accurate analysis of the complex spatial structure of heterogeneous hydrocarbon reservoirs requires detailed geological models, i.e. fine resolution models. Due to the high computational cost of simulating such models, single resolution up-scaling techniques are commonly used to reduce the volume of the simulated models at the expense of losing the precision. Several multi-scale ...
متن کاملA study on the sub-structure and mechanical properties of friction stir processed AA 6061-T6 joints with ultra-fine grained structure
Ultra-fine grained (UFG) structure (~0.6 µm) was produced in the stir zone (SZ) of 6061-T6 aluminum alloy joints using friction stir processing (FSP) cooled by liquid nitrogen (N2). A new experimental set-up was used to simultaneously quench the lower and upper surfaces of the samples during the processing. In addition, FSPed joints, using a steel backing plate, were produced at room temperatur...
متن کاملEffect of heat treatment on the grain structure and mechanical properties of Al-7075 friction stir weld
The fine grain structure of friction-stir welded aluminum alloys is unstable during post weld heat treatment and some grains abnormally grown. In this study, the sequence of abnormal grain growth during T6 heat treatment of Al-7075 friction-stir weld and its effect on mechanical properties of the weld was studied. The results showed that heat treatment in 510 ˚C resulted in drastic grain growth...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2016