Modeling of Dielectric Barrier Discharge Plasma Actuator

Glow discharge at atmospheric pressure using a dielectric barrier discharge can induce fluid flow, and operate as an actuator for flow control. In this paper, we simulate the physics of a 2-D asymmetric actuator operating in Helium gas using a high-fidelity first principles-based numerical modeling approach to help improve our understanding of the physical mechanisms associated with such actuators. Fundamentally, there are two processes in the two half-cycles of the actuator operation, largely due to the difference in mobility between faster electrons and slower ions, and the geometric configurations of the DBD/electrodes. The first half-cycle is characterized by the deposition of the slower ion species on the insulator surface while the second half-cycle by the deposition of the electrons at a faster rate. A power-law (cubic) dependence on the voltage for the resulting force is observed, which indicates that larger force can be generated by increasing the amplitude. Furthermore, one can enhance the effectiveness of the actuator, by either increasing the peak value of the periodic force generation or by increasing the asymmetry between the voltage half-cycles or both. Overall, the increase in the lower electrode size, applied voltage and dielectric constant tends to contribute to the first factor, and the decrease in frequency of applied voltage tends to contribute to the second factor. However, the complex interplay between the above factors determines the actuator performance.