High-temperature magnetic properties of mechanically alloyed SmCo 5 and YCo5 magnets
نویسندگان
چکیده
The high-temperature coercivity of mechanically alloyed and subsequently annealed RCo5 (R= Sm and Y) is studied. The annealed materials have the hexagonal CaCu5 structure with 2 : 17 (or 1 : 7) regions as a minor phase. High-temperature magnetic measurements show that the coercivities of materials decrease with increasing temperature from room-temperature to 873 K, but that the temperature coefficient of the coercivity of YCo5 is much smaller than that of SmCo5. This behavior is explained in terms of the intrinsic temperature variation of the magnetocrystalline anisotropy.
منابع مشابه
The Effect of Heat Treatment on Microstructure and Magnetic Properties of Nd17Fe76.5B5Cu1.5 Type Sintered Magnets
The effects of high temperature homogenization and low temperature annealing treatments on the microstructure and magnetic properties of sintered magnets of an Nd17Fe76.5B5Cu1.5 type alloy have been investigated. The microstructure of the as-cast alloy, consisted of three phases including a Nd2Fe14B1 (2:14:1- type) matrix phase Cu-containing Nd-rich Phase and Free α-iron. The as-sintered magnet...
متن کاملEffect of Fe, Cu, Zr, and Ti on the Magnetic Properties of SmCo-1 : 7 Magnets - Magnetics, IEEE Transactions on
The effect of Fe, Cu, Zr, and Ti substitution on magnetic properties of SmCo 1 : 7 magnets at temperatures up to 500 C were studied. As-milled amorphous Sm(Co,Fe,Cu,Ti–Zr)7 magnets crystallized in the TbCu7-type structure after annealing at 750 C for 2 h. A room-temperature intrinsic coercivity of around 2.5 T is obtained for compositions SmCo6 4Zr0 2Ti0 4 and SmCo6 4Fe0 1Zr0 1Ti0 4. The high c...
متن کاملSelf-nanoscaling of the soft magnetic phase in bulk SmCo/Fe nanocomposite magnets
Fabrication of bulk nanocomposite materials, which contain a magnetically hard phase and a magnetically soft phase with desired nanoscale morphology and composition distribution has proven to be challenging. Here we demonstrate that SmCo/Fe(Co) hard/soft nanocomposite materials can be produced by distributing the soft magnetic a-Fe(Co) phase particles homogenously in a hard magnetic SmCo phase ...
متن کاملThe Effect of Heat Treatment on Microstructure and Magnetic Properties of Nd17Fe76.5B5Cu1.5 Type Sintered Magnets
The effects of high temperature homogenization and low temperature annealing treatments on the microstructure and magnetic properties of sintered magnets of an Nd17Fe76.5B5Cu1.5 type alloy have been investigated. The microstructure of the as-cast alloy, consisted of three phases including a Nd2Fe14B1 (2:14:1- type) matrix phase Cu-containing Nd-rich Phase and Free α-iron. The as-sintered magnet...
متن کاملFerromagnetic Nanoparticles: Synthesis, Processing, and Characterization
Ferromagnetic nanoparticles are building blocks of future high density recording media and high performance permanent magnets. However, it is very challenging to produce nanoparticles with ferromagnetism at room temperature. The author describes recent progress in preparing ferromagnetic nanoparticles. Ferromagnetic nanoparticles can be used as building blocks for advanced bulk and thin fi lm m...
متن کامل