Effect of Amount of Deformation on the Martensitic Transformation and Shape Memory Effect in Fe-Mn-Si based Shape Memory Steel
نویسندگان
چکیده
The effect of amount of deformation on the martensitic transformation and shape memory effect in a Fe-16Mn-5Si-9Cr-4Ni alloy is studied. It is found that both 6and a'martensite are induced by deformation. With increasing amount of deformation, y+~-nx' transformation is greatly enhanced. the highest shape memory strain 3 3% is reached when the amount of deformation is about 5%.
منابع مشابه
Production and Characterization of Stainless Steel Based Fe-Cr-Ni-Mn-Si(-CO) Shape Memory Alloys
It is well known that the Fe based alloys can exhibit shape memory effect due to the y to E martensitic transformation. The effect may not be as striking as observed in the NiTi alloy but it might become attractive fkom the practical point of view. In this work, two compositions of Fe-Cr-Ni-Mn-Si(-Co) stainless steel based shape memory alloy, prepared by the VIM technique, will be presented. Th...
متن کاملEffect of Electrical Current on Nitinol Medical Staples Shape Memory
Medical staples are one of the nitinol shape memory alloys applications which their pedicles have to be bent for suitable function with an appropriate angle at a specified temperature .It is achievable by shape memory effect. For this purpose, samples of nitinol super elastic alloys were bent in a steel mold with different angles & formed orthopedic staples. Then shape memory effect was induced...
متن کاملEffect of Electrical Current on Nitinol Medical Staples Shape Memory
Medical staples are one of the nitinol shape memory alloys applications which their pedicles have to be bent for suitable function with an appropriate angle at a specified temperature .It is achievable by shape memory effect. For this purpose, samples of nitinol super elastic alloys were bent in a steel mold with different angles & formed orthopedic staples. Then shape memory effect was induced...
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملEffect of the Primary Microstructures during Training Producers on TWSME in NiTi Alloys (TECHNICAL NOTE)
The influence of the martensitic, martensitic+austenitic and austenitic structures in bending training on two-way shape memory effect (TWSME) in Ni-50.8 at %Ti and Ni-49.9 at %Ti alloys was studied. In addition of the primary structure, the effect of pre-strain, plastic strain, training cycle and training temperature on the TWSME was investigated. The prepared samples were trained in martensiti...
متن کامل