A quantitative method for determining spatial discriminative capacity

نویسندگان

  • Zheng Zhang
  • Vinay Tannan
  • Jameson K Holden
  • Robert G Dennis
  • Mark Tommerdahl
چکیده

BACKGROUND The traditional two-point discrimination (TPD) test, a widely used tactile spatial acuity measure, has been criticized as being imprecise because it is based on subjective criteria and involves a number of non-spatial cues. The results of a recent study showed that as two stimuli were delivered simultaneously, vibrotactile amplitude discrimination became worse when the two stimuli were positioned relatively close together and was significantly degraded when the probes were within a subject's two-point limen. The impairment of amplitude discrimination with decreasing inter-probe distance suggested that the metric of amplitude discrimination could possibly provide a means of objective and quantitative measurement of spatial discrimination capacity. METHODS A two alternative forced-choice (2AFC) tracking procedure was used to assess a subject's ability to discriminate the amplitude difference between two stimuli positioned at near-adjacent skin sites. Two 25 Hz flutter stimuli, identical except for a constant difference in amplitude, were delivered simultaneously to the hand dorsum. The stimuli were initially spaced 30 mm apart, and the inter-stimulus distance was modified on a trial-by-trial basis based on the subject's performance of discriminating the stimulus with higher intensity. The experiment was repeated via sequential, rather than simultaneous, delivery of the same vibrotactile stimuli. RESULTS Results obtained from this study showed that the performance of the amplitude discrimination task was significantly degraded when the stimuli were delivered simultaneously and were near a subject's two-point limen. In contrast, subjects were able to correctly discriminate between the amplitudes of the two stimuli when they were sequentially delivered at all inter-probe distances (including those within the two-point limen), and improved when an adapting stimulus was delivered prior to simultaneously delivered stimuli. CONCLUSION Subjects' capacity to discriminate the amplitude difference between two vibrotactile stimulations was degraded as the inter-stimulus distance approached the limit of their two-point spatial discriminative capacity. This degradation of spatial discriminative capacity lessened when an adapting stimulus was used. Performance of the task, as well as improvement on the task with adaptation, would most likely be impaired if the cortical information processing capacity of a subject or subject population were systemically altered, and thus, the methods described could be effective measures for use in clinical or clinical research applications.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Spatial Analysis and Quantitative Assessment of Rural Housing Indicators in Iran

Introduction Housing has been one of the most essential needs of human life for a long time and it is one of the most important symbols of civilization and culture. Providing a shelter which is safe and secure is everyone’s ambition and to reach to this aim, human beings have used many different methods and technologies to improve the quality and quantity of housing. Through time passage and...

متن کامل

Comparision of Methods for Determining Bearing Capacity of Piles Using Standard Penetration Test (SPT) Data

In recent years, determining bearing capacity of piles from in-situ testing data as a complement to static and dynamic analysis has been used by geotechnical engineers. In this paper, different approaches for estimating bearing capacity of piles from SPT data are studied and compared. A new method based on N value from SPT is presented. Data averaging, &#10failure zone and plunging failure of p...

متن کامل

Comparision of Methods for Determining Bearing Capacity of Piles Using Standard Penetration Test (SPT) Data

In recent years, determining bearing capacity of piles from in-situ testing data as a complement to static and dynamic analysis has been used by geotechnical engineers. In this paper, different approaches for estimating bearing capacity of piles from SPT data are studied and compared. A new method based on N value from SPT is presented. Data averaging, failure zone and plunging failure of pil...

متن کامل

Determining Teachers’ Professional Qualifications in “The Learning Approach to Knowing” and Presenting Executive Strategies for Realization of this Approach: A Mixed-Method Research

The present study aims at determining teachers’ professional qualifications in “the learning approach to knowing” and presenting executive strategies for realization of this approach. The research employs an exploratory mixed-method research. The population in the qualitative part of the research consists of experts of education and in the quantitative part includes all high school teachers of ...

متن کامل

A New Method for Hybrid Energy Storage Capacity Determination in Isolated Micro Grid

In recent years, hybrid energy storage (HES) to increase lifetime and reliability extremely are used in renewable systems and microgrids. In this paper, a new method for determining battery and supercapacitor capacity in an isolated microgrid is presented. Difference between Generation and load power using discrete fourier transform is transferred to the frequency domain and by determining the ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:
  • BioMedical Engineering OnLine

دوره 7  شماره 

صفحات  -

تاریخ انتشار 2008