A Note on Residual Stress , Lattice Orientation
ثبت نشده
چکیده
منابع مشابه
Determination of Residual Stress of PACVD Nanostructure TiN Coatings by GIXRD Method
In this study, thin layers of titanium nitride (TiN) were deposited on H13 steel substrates at different duty cycles and temperature of 520 ˚C using plasma assisted chemical vapor deposition (PACVD). Uniaxial residual stress was calculated by X-ray diffraction (XRD) and Sin2 Ψ method. Then the residual stress of the samples were measured by Grazing Incidence X-ray Diffraction (GIXRD) method and...
متن کاملDeformation twinning and residual stress in calcite studied with synchrotron polychromatic X-ray microdiffraction
Microstructures of deformed calcite in marble from the Bergell Alps are studied by using a microfocused polychromatic synchrotron X-ray beam. The high spatial resolution, together with orientation and strain resolutions, reveals twin plane orientation, multiple twin lamellae, and strain distributions associated with the twins. Single and multiple mechanical twins on e 1⁄4 0118 systems are confi...
متن کاملModelling of Resonance Frequency of MEMS Corrugated Diaphragm for Capacitive Acoustic Sensors (TECHNICAL NOTE)
In this paper, a new model for resonance frequency of clamped circular corrugated diaphragm has been presented. First, an analytical analyzes has been carried out to derive mathematic expressions for mechanical sensitivity of diaphragm with residual stress. Next by using Rayleigh's method we present mathematical model to calculate the resonance frequency of corrugated diaphragm and investigate ...
متن کاملExperimental Characterization and Simulation of Three Dimensional Plastic Deformation Induced by Microscale Laser Shock Peening
Different experimental techniques and 3D FEM simulations are employed to characterize and analyze the three dimensional plastic deformation and residual strain/stress distribution for single crystal Aluminum under microscale laser shock peening assuming finite geometry. Single pulse shock peening at individual locations was studied. X-ray microdiffraction techniques based on a synchrotron light...
متن کاملAn Investigation of the Accuracy of Diffraction Stress Evaluation of Textured Materials
The determination of residual or applied stress through X-ray or neutron diffraction is generally regarded as a mature method. Most x-ray diffractometers can be used to perform a measurement of lattice strain vs. tilt angle, which is then converted into stress. The apparent simplicity of the conversion (the sinø law comes to mind) betrays the fact that elastic and plastic anisotropy often cause...
متن کامل