A 1.8 GHz CMOS Low-Noise Amplifier
نویسندگان
چکیده
A 1.8 GHz low-noise amplifier has been designed and fabricated in a standard 0.35 pm CMOS process. Measurement results indicate that the amplifier has a forward gain (S21) of 10.5 dB and a noise figure of 3.94 dB, while consuming 40 mW from a 2.5 V supply.
منابع مشابه
Analysis and design of a CMOS current reused cascaded distributed amplifier with optimum noise performance
In this paper, analysis, simulation and design of a distributed amplifier (DA) with 0.13µm CMOS technology in the frequency range of 3-40 GHz is presented. Gain cell is a current reused circuit which is optimum in gain, noise figure, bandwidth and also power dissipation. To improve the noise performance in the frequency range of interest, a T-matching low pass filter LC network which is utilize...
متن کاملA Broadband Low Power CMOS LNA for 3.1–10.6 GHz UWB Receivers
A new approach for designing an ultra wideband (UWB) CMOS low noise amplifier (LNA) is presented. The aim of this design is to achieve a low noise figure, reasonable power gain and low power consumption in 3.1-10.6 GHz. Also, the figure of merit (FOM) is significantly improved at 180nm technology compared to the other state-of-the-art designs. Improved π-network and T-network are used to obt...
متن کاملA New Ultra-Wideband Low Noise Amplifier With Continuous Gain Control
This paper presents a new variable gain low noise amplifier (VG-LNA) for ultra-wideband (UWB) applications. The proposed VG-LNA uses a common-source (CS) with a shunt-shunt active feedback as an input stage to realize input matching and partial noise cancelling. An output stage consists of a gain-boosted CS cascode and a gain control circuit that moves the high resonant frequency to higher freq...
متن کامل1.8 dB NF 3.6 mW CMOS active balun low noise amplifier for GPS
A 1.227 GHz low power single-ended input, differential output low noise amplifier (balun LNA) for GPS is proposed. A two stage structure with current-reused technique is adopted to achieve low power, low noise factor and high voltage gain simultaneously. The LNA is fabricated in 0.18 mm CMOS process, consuming only 2 mA current from a 1.8 V supply. The LNA is measured to exhibit a differential ...
متن کاملA 2.4-Ghz Differential Low-noise Amplifiers using 0.18um CMOS Technology
A 2.4-GHz inductive degenerate differential narrowband low-noise amplifiers (LNAs) using 0.18um CMOS Technology are presented in this paper. The LNA is properly biased operates at 1.8 volts power supply and perfectly matched input impudence of 50 ohms. The LNA has the Noise figure <2.5dB, Gain(S21) >20dB,Input impedance (S11) <-20dB, Output impedance (S22) <-10dB,IIP3>-10dBm.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2008