Wideband Microstrip-fed Printed Bow-tie Antenna for Phased- Array Systems
نویسندگان
چکیده
A microstrip-fed printed bow-tie antenna is presented in order to achieve wide bandwidth, high gain, and size reduction. A comparison between the bow-tie and the quasi-Yagi (dipole and director) antennas shows that the bow-tie antenna has a wider bandwidth, higher gain, lower front-to-back ratio, lower cross-polarization level, and smaller size. Two-element arrays are designed and their characteristics are compared. The bow-tie antenna yields lower coupling for the same distance between elements. © 2004 Wiley Periodicals, Inc. Microwave Opt Technol Lett 43: 123–126, 2004; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.20396
منابع مشابه
Design and Implementation of a Compact Super-Wideband Printed Antipodal Antenna Using Fractal Elements
A compact printed fractal antipodal bow-tie antenna is designed and implemented to simultaneously cover the operations in the C, X, and Ku-bands. It is demonstrated that by addition of small fractal elements at the sides of hexagonal arms of the bow-tie, a wide operating frequency range of 3.3 to 19.1 GHz can be covered while antenna size is only 30×34×1.2 mm3. In order to match the antenna to ...
متن کاملWideband Microstrip-fed Printed Bow-tie Antenna for Phasedarray Systems
A micro strip-fed printed bow-tie antenna is presented inorder to achieve wide bandwidth, high gain, and size reduction. A comparisonbetween the bow-tie and the quasi-Yagi (dipole and director)antennas shows that the bow-tie antenna has a wider bandwidth, highergain, lower front-to-back ratio, lower crosspolarization level, andsmaller size. Two-element arrays are designed and their characterist...
متن کاملUWB Planar Conical Horn-Shaped Self-Complementary Bow-Tie Antenna
An ultra-wideband (UWB) self-complementary planar bow-tie antenna (SCPBTA) is proposed. The antenna consists of a printed conical horn-shaped (CHS) radiator and a counterpart CHS slot etched on a rectangular ground plane. The printed CHS radiator is connected directly to the 50Ω microstrip line by bending the end portion of the feed line. As a result, the antenna has a simple structure which do...
متن کاملDesign Investigation of Microstrip Patch and Half-Mode Substrate Integrated Waveguide Cavity Hybrid Antenna Arrays
In this paper two linear arrays including a linear 1×4 and a planar 2×2 of microstrip patch and half-mode substrate integrated waveguide (SIW) cavity hybrid antenna are introduced and investigated. These are simply implemented using low cost single layer printed circuit board (PCB) process. The array element consists of a rectangular microstrip patch with appropriate dimensions in the vicinity ...
متن کاملUltra-Wideband Fermi Antenna Using Microstrip-to-CPS Balun
A new design and experimental results of a microstripfed ultra-wideband Fermi antenna at millimeter-wave frequencies are presented. By utilizing a new microstrip-to-CPS balun (or transition), which provides wider bandwidth than conventional planar balun, the design of microstrip-fed Fermi antenna is greatly simplified. The proposed Fermi antenna demonstrates ultra-wideband performance for the f...
متن کامل