Auto-calibration of capacitive MEMS accelerometers based on pull-in voltage
نویسندگان
چکیده
This paper describes an electro-mechanical auto-calibration technique for use in capacitive MEMS accelerometers. Auto-calibration is achieved using the combined information derived from an initial measurement of the resonance frequency and the measurement of the pull-in voltages during device operation, with an estimation of process-induced variations in device dimensions from layout and deviations in material properties from the known nominal value. An experiment-based analytical model is used to compute the required electrostatic forces required to simulate external accelerations allowing the electro-mechanical calibration of the accelerometer. Measurements on fabricated devices confirm the validity of the proposed technique and electro-mechanical calibration is experimentally demonstrated.
منابع مشابه
Accurate Determination of the Pull-in Voltage for MEMS Capacitive Microphone with Clamped Square Diaphragm
Accurate determination of the pull-in, or the collapse voltage is critical in the design process. In this paper an analytical method is presented that provides a more accurate determination of the pull-in voltage for MEMS capacitive devices with clamped square diaphragm. The method incorporates both the linearized modle of the electrostatic force and the nonlinear deflection model of a clamped ...
متن کاملA MEMS Capacitive Microphone Modelling for Integrated Circuits
In this paper, a model for MEMS capacitive microphone is presented for integrated circuits. The microphone has a diaphragm thickness of 1 μm, 0.5 × 0.5 mm2 dimension, and an air gap of 1.0 μm. Using the analytical and simulation results, the important features of MEMS capacitive microphone such as pull-in voltage and sensitivity are obtained 3.8v and 6.916 mV/Pa, respectively while there is no...
متن کاملModel Reduction for Pull-in Voltage Analysis of SOI MEMS based Capacitive Accelerometer
In general, MEMS accelerometers fabrication relies more on trial and error than on clear design principles. Since the trial and error basis fabrication and testing of a MEMS are extremely costly, comprehensive modeling and simulation can be valuable tool to evaluate different designs and perform parametric studies each MEMS design before actual fabrication. This paper presents work done for SOI...
متن کاملEffects of the Residual Stress and Bias Voltage on the Phase Diagram and Frequency Response of a Capacitive Micro-Structure
In this paper, static and dynamic behavior of a varactor of a micro-phase shifter under DC, step DC and AC voltages and effects of the residual stress on the phase diagram have been studied. By presenting a mathematical modeling, Galerkin-based step by step linearization method (SSLM) and Galerkin-based reduced order model have been used to solve the governing static and dynamic equations, resp...
متن کاملEffect of Temperature Changes on Dynamic Pull-in Phenomenon in a Functionally Graded Capacitive Micro-beam
In this paper, dynamic behavior of a functionally graded cantilever micro-beam and its pull-in instability, subjected to simultaneous effects of a thermal moment and nonlinear electrostatic pressure, has been studied. It has been assumed that the top surface is made of pure metal and the bottom surface from a metal–ceramic mixture. The ceramic constituent percent of the bottom surface ranges fr...
متن کامل