Target and Trajectory Clinical Application

نویسنده

  • Reuben R. Shamir
چکیده

BACKGROUND: Catheter, needle, and electrode misplacement in navigated neurosurgery can result in ineffective treatment and severe complications. OBJECTIVE: To assess the Ommaya ventricular catheter localization accuracy both along the planned trajectory and at the target. METHODS: We measured the localization error along the ventricular catheter and on its tip for 15 consecutive patients who underwent insertion of the Ommaya catheter surgery with a commercial neuronavigation system. The preoperative computed tomography/magnetic resonance images and the planned trajectory were aligned with the postoperative computed tomography images showing the Ommaya catheter. The localization errors along the trajectory and at the target were then computed by comparing the preoperative planned trajectory with the actual postoperative catheter position. The measured localization errors were also compared with the error reported by the navigation system. RESULTS: The mean localization errors at the target and entry point locations were 5.96 4.3 and 3.3 6 1.9 mm, respectively. The mean shift and angle between planned and actual trajectories were 1.6 6 1.9 mm and 3.9 6 4.7 , respectively. The mean difference between the localization error at the target and entry point was 3.96 3.7 mm. The mean difference between the target localization error and the reported navigation system error was 4.9 6 4.8 mm. CONCLUSION: The catheter localization errors have significant variations at the target and along the insertion trajectory. Trajectory errors may differ significantly from the errors at the target. Moreover, the single registration error number reported by the navigation system does not appropriately reflect the trajectory and target errors and thus should be used with caution to assess the procedure risk.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Midcourse Trajectory Shaping for Air and Ballistic Defence Guidance Using Bezier Curves

A near-optimal midcourse trajectory shaping guidance algorithm is proposed for both air and ballistic target engagement mission attributes for generic long range interceptor missile. This guidance methodology is based on the maximum final velocity as the objective function and maximum permissible flight altitude as the in-flight state constraint as well as the head-on orientation as the termina...

متن کامل

Trajectory Optimization of Cable Parallel Manipulators in Point-to-Point Motion

Planning robot trajectory is a complex task that plays a significant role in design and application of robots in task space. The problem is formulated as a trajectory optimization problem which is fundamentally a constrained nonlinear optimization problem. Open-loop optimal control method is proposed as an approach for trajectory optimization of cable parallel manipulator for a given two-end-po...

متن کامل

Wellbore Trajectory Optimization of an Iranian Oilfield Based on Mud Pressure and Failure Zone

Determination of the borehole and fracture initiation positions is the main aim of a borehole stability analysis. A wellbore trajectory optimization with the help of the mud pressure may be unreasonable since the mud pressure can only reflect the degree of difficulty for the initial damage to occur at the wellbore rather than the extent of the wellbore damage. In this work, we investigate...

متن کامل

Formation Control and Path Planning of Two Robots for Tracking a Moving Target

This paper addresses the dynamic path planning for two mobile robots in unknownenvironment with obstacle avoidance and moving target tracking. These robots must form atriangle with moving target. The algorithm is composed of two parts. The first part of thealgorithm used for formation planning of the robots and a moving target. It generates thedesired position for the robots for the next step. ...

متن کامل

Maximum Allowable Load On Wheeled Mobile Manipulators (RESEARCH NOTE)

This paper develops a computational technique for finding the maximum allowable load of mobile manipulators for a given trajectory. The maximum allowable loads which can be achieved by a mobile manipulator during a given trajectory are limited by the number of factors; probably the dynamic properties of mobile base and mounted manipulator, their actuator limitations and additional constraints a...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2011