Influence of strain and pressure to the effective refractive index of the fundamental mode of hollow-core photonic bandgap fibers.

نویسندگان

  • M Pang
  • H F Xuan
  • J Ju
  • W Jin
چکیده

We investigate the phase sensitivity of the fundamental mode of hollow-core photonic bandgap fibers to strain and acoustic pressure. A theoretical model is constructed to analyze the effect of axial strain and acoustic pressure on the effective refractive index of the fundamental mode. Simulation shows that, for the commercial HC-1550-02 fiber, the contribution of mode-index variation to the overall phase sensitivities to axial strain and acoustic pressure are respectively approximately -2% and approximately -17%. The calculated normalized phase-sensitivities of the HC-1550-02 fiber to strain and acoustic pressure are respectively 1 epsilon(-1) and -331.6 dB re microPa(-1) without considering mode-index variation, and 0.9797 epsilon(-1) and -333.1 dB re microPa(-1) when mode-index variation is included in the calculation. The latter matches better with the experimentally measured results.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Gas Sensor Based on Large Hollow-Core Photonic Bandgap Fiber

One concern in using photonic band-gap fiber (PBGF) as a gas sensor is the response time. In this type of the gas sensors, response time is the time required for gas to diffuse into the hollow-core. So considering a large hollow-core PBGF (HC-PBGF), the response time can be significantly reduced. But in the large HC-PBGF, the fundamental issue is the presence of higher order modes (HOMs). Somet...

متن کامل

Resonant Biochemical Sensors Based on Photonic Bandgap Waveguides and Fibers

I describe photonic bandgap (PBG) fiber-based resonant optical sensors of analyte’s refractive index which have recently invoked strong interest due to the development of novel fiber types and of techniques for the activation of fiber microstructure with functional materials. Particularly, I consider two sensors types. One employs hollow-core photonic bandgap fibers where the core-guided mode i...

متن کامل

Photonic bandgap fiber tapers and in-fiber interferometric sensors.

Nonadiabatic tapers in hollow-core air-silica photonic bandgap fibers (PBFs) were fabricated by the use of a fiber fusion splicer. In addition to the well-known scaling down of fiber dimensions, the innermost rings of air holes were found collapsed or significantly deformed, which results in almost doubling the diameter of the hollow core in the tapered region. The tapering of the PBF causes co...

متن کامل

Numerical Analysis of Index-Guiding Photonic Crystal Fibers with Low Confinement Loss and Ultra-Flattened Dispersion by FDFD Method

In this article, perfectly matched layer (PML) for the boundary treatment and an efficient compact two dimensional finite-difference frequency-domain (2-D FDFD) method were combined to model photonic crystal fibers (PCF). For photonic crystal fibers, if we assume that the propagation constant along the propagation direction is fixed, three-dimensional hybrid guided modes can be calculated by us...

متن کامل

Comparative Study of Fundamental Properties of Honey Comb Photonic Crystal Fiber at 1.55μm Wavelength

Fundamental properties such as mode field distribution, real effective refractive index, imaginary effective refractive index, confinement loss of two new kinds of honeycomb photonic crystal fibers are successfully studied by using Full-Vectorial Finite element method (FV-FEM). Low confinement loss 0.1×10dB/km is achieved at wavelength 1.55μm in hollow core honey comb PCF by removing 6-air hole...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Optics express

دوره 18 13  شماره 

صفحات  -

تاریخ انتشار 2010