Development and Test of Nb3sn Cos-theta Coils Made of High-jc Rrp Strands
نویسندگان
چکیده
A series of 1-m long Nb3Sn dipole magnets have been built at Fermilab in an attempt to refine the wind-and-react technology for Nb3Sn conductor. Models have been made with MJR and PIT strand with varying degrees of success. Subsequently two new dipole “mirror” magnets based on RRP Nb3Sn coils were constructed and tested. This paper describes the design, fabrication and test results of those magnets.
منابع مشابه
Performance Boost in Industrial Multifilamentary Nb3Sn Wires due to Radiation Induced Pinning Centers
We report non-Cu critical current densities of 4. 09 ⋅ 10(9) A/m(2) at 12 T and 2.27 ⋅ 10(9) A/m(2) at 15 T obtained from transport measurements on a Ti-alloyed RRP Nb3Sn wire after irradiation to a fast neutron fluence of 8.9 ⋅ 10(21) m(-2). These values are to our knowledge unprecedented in multifilamentary Nb3Sn, and they correspond to a Jc enhancement of approximately 60% relative to the un...
متن کاملThe Influence of Nb3Sn Strand Geometry on Filament Break- age under Bend Strain as Re- vealed by Metallography
The non-Cu critical current density of Nb3Sn strands has been pushed towards 3000 A/mm2 (12 T, 4.2 K) by increasing the Sn content and reducing the interfilamentary Cu. We compare the susceptibility to A15 filament breakage (under 0.5% bend strain) of the new high-Jc internal Sn conductor geometries with both high-Jc Powder-in-Tube (PIT) and low hysteresis loss distributed filament ITER designs...
متن کاملQuench Analysis of High Current Density Nb3Sn Conductors in Racetrack Coil Configuration
The luminosity upgrade of the Large Hadron Collider (HL-LHC) requires the development of new type of superconducting cables based on advanced Nb3Sn strands. In the framework of the FP7 European project EUCARD the cables foreseen for the HL-LHC project have been tested recently in a simplified racetrack coil configuration, the so-called Short Model Coil (SMC). In 2013 to 2014, two SMCs wound wit...
متن کاملNb3Sn Wire Technology for High-field Superconducting Magnet
Nb3Sn superconducting wires are widely used for highfield superconducting magnets, and the NMR magnet is one of the most successful applications. In order to realize a large Jc (critical current density), which is essential to high-field superconducting magnets, several different types of production methods have been developed, such as the bronze-route method, the powderin-tube method and the i...
متن کاملDESIGN MODIFICATIONS, FABRICATION AND TEST OF HFDB-03 RACETRACK MAGNET WOUND WITH PRE-REACTED Nb3Sn RUTHERFORD CABLE
A 10 T racetrack magnet (HFDB-03) wound with pre-reacted Nb3Sn Rutherford cable has been fabricated and tested at Fermilab. This magnet is the third one in a proof-ofprinciple series for the use of the React-and-Wind technology in common-coil dipole magnets for future accelerators. It consists of two flat racetrack coils (28 turns each) separated by 5 mm. The maximum field on the coil, at the s...
متن کامل