Dynamic compensation of reactive power in Various Faults in Power System

The STATCOM (Synchronous Static Compensator) based on voltage source converter (VSC) is used for voltage regulation in transmission and distribution system. The STATCOM can rapidly supply dynamic VARs required during system faults for voltage support. Strict requirements of STATCOM losses and total system loss penalty preclude the use of PWM (Pulse-Width Modulation) for VSC based STATCOM applications. This constraint of implementing VSC without PWM functionality, results in over-currents and trips of the STATCOM during and after system faults, when its VAR support functionality is most required. In this paper, we propose and develop an “emergency PWM” strategy to prevent over-currents (and trips) in the VSC during and after single line to ground system faults, LLLG faults and to ensure that the STATCOM supplies required reactive power. The Simulation results are shown for a 48-pulse VSC based ± 100 MVAR STATCOM connected to a 2bus power strategy to prevent VSC over-currents and to supply required reactive power under line to ground system faults.