Compression and evaluation of extended release matrix pellets prepared by the extrusion/spheronization process into disintegrating tablets

In this study, a novel approach for compression of matrix pellets into disintegrating tablets has been studied in an attempt to overcome the issues pertaining to rupture of polymer coat during compression of reservoirtype pellets. Extended release matrix pellets were prepared by the extrusion/spheronization technique using commercially available aqueous dispersions of ethyl cellulose, acrylic polymers and sodium alginate at 10%, 20% and 30%w/w levels. Sertraline hydrochloride was used as the model drug and an in vitro release profile of 12 h was targeted. Tablets containing matrix pellets were prepared by the direct compression process. Acceptance Value, a pharmacopeial test, was applied to study the uniformity of drug distribution. Effect of compression force (2-6 kN), extrusion screen aperture size, diluent blend composition and pellet percentage on drug release and acceptance value were studied. As polymer is uniformly distributed within each pellet, the drug release pattern from uncompressed pellets was comparable to compressed tablets. Surface morphological changes due to calcium chloride treatment were observed using Scanning electron microscopy. The pellet segregated from the surface of the tablet was found to be flattened in the direction of applied compression force with minor deformities. In conclusion, matrix pellets can constitute an alternative approach to reservoir-type pellets in obtaining disintegrating tablets for extended delivery of drugs.