Flow Scales of Influence on the Settling Velocities of Particles with Varying Characteristics
نویسندگان
چکیده
The settling velocities of natural, synthetic, and industrial particles were measured in a grid turbulence facility using optical measurement techniques. Particle image velocimetry and 2D particle tracking were used to measure the instantaneous velocities of the flow and the particles' trajectories simultaneously. We find that for particles examined in this study (Rep = 0.4-123), settling velocity is either enhanced or unchanged relative to stagnant flow for the range of investigated turbulence conditions. The smallest particles' normalized settling velocities exhibited the most consistent trends when plotted versus the Kolmogorov-based Stokes numbers suggesting that the dissipative scales influence their dynamics. In contrast, the mid-sized particles were better characterized with a Stokes number based on the integral time scale. The largest particles were largely unaffected by the flow conditions. Using proper orthogonal decomposition (POD), the flow pattern scales are compared to particle trajectory curvature to complement results obtained through dimensional analysis using Stokes numbers. The smallest particles are found to have trajectories with curvatures of similar scale as the small flow scales (higher POD modes) whilst mid-sized particle trajectories had curvatures that were similar to the larger flow patterns (lower POD modes). The curvature trajectories of the largest particles did not correspond to any particular flow pattern scale suggesting that their trajectories were more random. These results provide experimental evidence of the "fast tracking" theory of settling velocity enhancement in turbulence and demonstrate that particles align themselves with flow scales in proportion to their size.
منابع مشابه
Fluid Flow and Heat Transfer of Nanofluids over a Flat Plate with Conjugate Heat Transfer
The falling and settling of solid particles in gases and liquids is a natural phenomenon happens in many industrial processes. This phenomenon has altered pure forced convection to a combination of heat conduction and heat convection in a flow over a plate. In this paper, the coupling of conduction (inside the plate) and forced convection of a non-homogeneous nanofluid flow (over a flat plate) ...
متن کاملDeposition of Various Shapes Particles on a Rough Surface in Turbulent Flow
An experiment set-up is used to study wall deposition rate of particles on a rough surface in a turbulent channel flow. Deposition velocities for three classes of particles, namely, spherical glass particles, irregular shape polymer particles, and fibrous silicon particles are studied. The particle concentration at the test section was measured with the aid of an isokinetic probe in conjunction...
متن کاملThe effect of flow parameters on mixing degree of a three dimensional rhombus micromixer with obstacles in the middle of the mixing channel using oscillatory inlet velocities
The previous studies of authors on passive micromixers indicated that the micromixers dividing the flow to several layers, such as rhombus micromixers and micromixers with obstacles in the middle of the mixing channel, have higher mixing degree than other types. Also, using of oscillatory inlet velocities is an active method to enhance the mixing efficiency of micromixers. Therefore, in this st...
متن کاملInvestigating the effect of Inlet and Outlet location on Flow field and Sedimentation pattern of a rectangular settling basin using CCHE2D
Water obtained from any source may contain impurities induced by erosion, dissolved minerals, dissolved gases and material produced from organic matter decomposing. If the amount of these substances exceed a certain limit, not only the water would not be potable, but the water containing the material will not be suitable to be used in most applications, or at least before treatment cannot be ap...
متن کاملInfluence of Nano-Particles on Characteristics of MetakaolinContained Cement Paste
The influences of nano-ZrO2 (NZ), nano-TiO2 (NT), nano-Fe2O3 (NF) and nano-Al2O3 (NA) additions on properties of the fresh and hardened cement paste in comparison with the fine cement paste were experimentally studied. Mini slump and flow cone tests were conducted on fresh cement pastes. Moreover the compressive and tensile strength of hardened cement paste were measured. SEM micrographs and XR...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره 11 شماره
صفحات -
تاریخ انتشار 2016