Self-assembly of a hydrophobically modified naphthalene-labeled poly(acrylic acid) polyelectrolyte in water: organic solvent mixtures followed by steady-state and time-resolved fluorescence.
نویسندگان
چکیده
The solution properties of two water-soluble polymers, poly(acrylic acid) (PAA), covalently labeled with the fluorescent hydrophobic dye naphthalene (Np), have been investigated in water:organic solvent mixtures. The naphthalene chromophores have been randomly attached, onto the polymer, with two different degrees of labeling. Fluorescence measurements (steady-state and time-resolved) have been used to follow the photophysical behavior of the polymers and consequently report on the self-association of the polymers in the mixed organic (methanol or dioxane):aqueous solutions. The emission spectra of the high-labeled Np PAA reveal the presence of monomer and excimer bands whereas with the low-labeled polymer only monomer emission is observed. The excitation spectra collected at the monomer and excimer emission bands show significant differences, depending on the water content of the mixture, which indicate the simultaneous presence of preformed and dynamic dimers as routes to excimer formation. The time-resolved data decay profiles of the high-labeled polymer in the mixtures were always triple exponential whereas in pure methanol and dioxane they follow biexponential laws. The data in the mixtures are consistent with two types of monomers and one excimer. Both monomers are able to give rise to excimer in the excited state, one type involving the movement of long distant Np chromophores and the other involving a local reorientation of adjacent Np chromophores. These correspond to different decay times: (1) a long which corresponds to the long distant approach of non-neighboring Np chromophores forming an excimer and (2) a short corresponding to the fast adjustment of two neighboring Np chromophores in order to have the adequate parallel geometry. An additional decay time corresponding to the excimer decay was found to be present at all wavelengths. All the decay times were dependent on the water content of the mixture. An estimation of the two excimer forming rate constants values is made for the mixed media considered in this work. On the whole, using both steady-state and time-resolved fluorescence parameters, and by comparing data for a polymer with a small number of hydrophobes with a more highly modified one, it is possible in great detail to demonstrate how association is controlled by solvent quality for the hydrophobes and by the distance between hydrophobes.
منابع مشابه
Association of a hydrophobically modified polyelectrolyte and a block copolymer followed by fluorescence techniques.
By using absorption and fluorescence (steady-state and time-resolved) techniques, the interaction between a poly(acrylic acid) (PAA), randomly grafted with pyrene (Py) units (PAAMePy55), and a triblock copolymer of poly(ethylene oxide) and poly(propylene oxide) (EO(20)PO(68)EO(20), P123) was investigated. From the fluorescence data, it is shown that upon addition of P123 a decrease of the (pyre...
متن کاملSynthesis of pH Sensitive Hydrogels Based on Poly Vinyl Alcohol and Poly Acrylic Acid
In this research, hydrogels based on poly vinyl alcohol and poly acrylic acid blend were prepared which were cross-linked by applied thermal conditions. Afterward, effects of time and heating on water uptake were investigated. The highest water uptake value exhibited by the sample that was heated for 20 min. at 110 ºC was about 2129% after 4 days at equilibrium state. Hydrogels exhibited p...
متن کاملThin films of hydrophobically modified poly(N,N-dimethylacrylamide).
The behavior of a poly(N,N-dimethylacrylamide) hydrophobically modified by incorporating 0.33 mol % of a pyrenyl derivative, [4-(1-pyrenyl)butyl]amine hydrochloride (PY) and 3.56 mol % of dodecylamine (DO) has been studied at the air/water interface. Surface pressure-area isotherm measurements show that the film is initially anchored by the hydrophobic groups at the air-water interface with a p...
متن کاملFabrication and Characterization of Chitosan/Alginate Multilayer Composite Membrane Supported by a Porous Poly (Acrylonitrile) Substrate for Pervaporation Dehydration of Alcohol
Chitosan (CS) and alginate (Alg) are complementary in their membrane performance, but the combination of them is normally difcult to use due to their different solubilities. Layer-by-Layer deposition appears to be an effective method for improving the separation efciency of a composite membrane. In this work, the polyelectrolyte multilayer composite membranes (PEMCMs) wer...
متن کاملPreconcentration of Zn(II) in Water Sample Using Modified NanoFiber
A new simple and reliable method for rapid and selective extraction and determination of trace levels of Zn(II) ion is developed. Zn(II) ions are adsorbed quantitatively during passage of aqueous samples through PET-AA/AAm nano fiber modified. Almost all matrix elements were found to pass through the nano fiber to drain. Modified Poly (ethylene terephthalate)-grafted-Acrylic acid/Acryl amide Na...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- The journal of physical chemistry. B
دوره 109 8 شماره
صفحات -
تاریخ انتشار 2005