Evaluation of the lubricant properties of Esterified Estolide
ثبت نشده
چکیده
6.
منابع مشابه
Evaluation of the compression process diagram in presence of magnesium stearate
In the pharmaceutical industry is no longer worked without instrumented tablet presses. The recording of the press information at different parameters of each test series and batches in the development of tablets and an online measurement and control of pressing forces during the production process is becoming increasingly important. Eccentric tablet presses were equipped with sensors for the u...
متن کاملSynthesis and Physical Properties of Estolide Ester Using Saturated Fatty Acid and Ricinoleic Acid
A study was conveyed to produce estolide ester using ricinoleic acid as the backbone. The ricinoleic acid reacted with saturated fatty acid from C8-C18. These reactions were conducted under vacuum at 60°C for 24 h without solvent. The reaction used acid catalyst, sulphuric acid. The new saturate ricinoleic estolide esters show superior low-temperature properties (-52 ± 0.08°C) and high flash po...
متن کاملTribological behavior of sputter-deposited MoSX/Ni coatings
AbstractSputtered MoS2 coatings have been mostly used as a solid lubricant. In this investigation, MoSx/Ni composite coatings with Ni contents varying from 0 to 22 % were deposited onto steel substrate using a DC magnetron sputter process. The MoS2/Ni ratio in the coatings was controlled by sputtering the composite targets. The composition, microstructure, and mechanical properties of the...
متن کاملMolecular dynamics simulation of a binary mixture lubricant for use in hard disk interfaces
In Hard Disk Drives (HDD), it is necessary to decrease the Flying Height (FH) between the head and the disk (currently, FH is around 3-5 nm) so as to increase recording densities. Retaining the solid lubricant has become a difficult proposition owing to intermittent contact between the surfaces. ZTMD and Z are used as solid lubricant to lubricate these interfaces. In this paper, the behavior of...
متن کاملStudy of Catalyst and Co- Catalyst Effect on Preparation of Lubricant from Heavy Propylene Tetramer (HPT)
In this research we used Heavy Propylene Tetramer (HPT) and A1C13 —BF3 (Lewis acids) ascatalyst and ethanol, n-propanol and n-butanol as co-catalyst. Using Lewis acids as catalyst, theHPTs form molecules with higher molecular weight. Since the raw materials of the reaction are byproducts of other reactions, are not pure and contain various compounds with different M.W andalso different chemical...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2010