Multivariable controller design for a hot rolling mill
نویسندگان
چکیده
منابع مشابه
Optimization of Plate Thickness Controller
The purpose of the hot rolling mill is to make a preheated steel block thinner and longer, see Figure 1. This is done by pulling the plate through two parallel rolls mounted in the rolling mill. Due to the large forces obtained in hot rolling, the elastic de ection of the rolling mill is of the same order of magnitude as the plate thickness. Variations in the rolling force caused by variations ...
متن کاملSwitched system modeling and robust steering control of the tail end phase in a hot strip mill
In this article, a robust steering control for the last phase of the rolling process in a hot strip mill is proposed. This phase, called tail end phase, may be modelled as a linear switched system. The switchings make the system unstable and the task of the tail end steering control consists in guaranteeing the safety of the industrial plant. The system involves a two time scales dynamics. Henc...
متن کاملFeedforward control of lateral asymmetries in heavy-plate hot rolling using vision-based position estimation
This paper presents a feedforward control concept for lateral asymmetries in heavyplate hot rolling. A lateral off-center plate position generally entails asymmetric rolling forces, asymmetric mill stretch, and thus a wedge-shaped exit thickness that may cause a cambered plate contour and a rotatory motion of the plate. In this paper, a model of the mill stand and of the plate movement is prese...
متن کاملFuzzy Tuning PID Control of Strip Rolling Mill Hydraulic APC System
Hydraulic Automatic Position Control (APC) is a very important part of rolling mill for magnesium plate rolling. The control effect of automatic position control system influences the quality of the rolled product directly. APC system is an essentially nonlinear, time delay, time-varying, large inertia, multivariable and coupling complex system, which increase the designing difficulty of contro...
متن کاملInvestigations into the Effect of Tension Between the Stands of the Finishing Mill on Width Control in a Hot Rolling Process
This paper is concerned with investigations into the effect of tension between the stands of the finishing mill on width control in a hot rolling process. An analysis is given to predict satisfactorily the variation in width due to spreading and also due to strip tension between the stands. Wusatowski's model which is developed to give an account of spreading is specified and a similar model to...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- IEEE Trans. Contr. Sys. Techn.
دوره 6 شماره
صفحات -
تاریخ انتشار 1998