Modeling, Design, Fabrication, and Performance of Rectangular g-Coaxial Lines and Components
نویسندگان
چکیده
A miniature non-uniform copper-air rectangular coaxial line with the inner conductor supported by periodic dielectric straps is demonstrated. The overall height of the line is 310gm with the outer conductor cross-section being 250gmx250gm. The measured loss is 0.22dB/cm at 26GHz, while the isolation between two parallel lines with a center-to-center separation of 700gm is better than 60dB. Several quasi-planar components are designed and fabricated on the same wafer, and presented here are a branch-line hybrid and a transmission line resonator. The through and coupled port transmissions for the hybrid at 26GHz are -3.25dB and -3.35dB respectively, with phase misbalance below 0.2°. The transmission line resonator has an unloaded Q-factor of 110 at 25GHz. Index Terms Branch line hybrid, Coaxial line, Computer aided design, Transmission Line Resonator.
منابع مشابه
Design of Microfabricated Rectangular Coaxial Lines and Components for mm-Wave Applications
Miniature 310μm tall copper-air rectangular coaxial lines (RCL) with the inner conductor supported by periodic dielectric straps are demonstrated in this paper. The measured line loss is about 0.2dB/cm at 26GHz, while the isolation between two parallel lines with a center-to-center separation of 700μm is better than 60dB. Several quasi-planar components are designed and fabricated on the same w...
متن کاملDesign, simulation and Fabrication of Circularly Polarized Fabry-Perot Antenna for Ku Band
This paper deals with the design and simulation of a RHCP Fabry-Perot antenna for 14.5 GHz. Based on transmission line model, partially Reflecting Surface (PRS) was designed so thatgain enhancement and circular polarization simultaneously obtained. PRS consist of a square loop and meander-line at the top and bottom respectively. In order to achieve the resonance condition in orthogonal componen...
متن کاملDesign and Fabrication of an End-Launched Rectangular Waveguide Adapter Fed by a Coaxial Loop
An end-launched adapter combining a coaxial loop within a rectangular waveguide has been analyzed and designed. The accurate electromagnetic modeling of input impedance for the adapter design has been developed using a modal analysis method. Also, design parameters to improve the end-launched adapter have been investigated. Numerical and experimental results of the proposed model have been comp...
متن کاملIntegrated Micro-coaxial Passive Components for Millimeter-wave Antenna Front Ends
Miniature 250 to 700-μm tall copper air-filled rectangular coaxial line with inner conductor supported by periodic dielectric straps is demonstrated. The measured loss is as low as 0.08dB/cm at 37GHz, while the isolation between two parallel lines with center-to-center separation of 350μm is better than 60dB. A number of quasi-planar components are designed to be fabricated on the same 6inch wa...
متن کاملDesign and Characterization of Microfabricated Three-Dimensional Millimeter-Wave Components
Date The final copy of this thesis has been examined by the signatories, and we find that both the content and the form meet acceptable presentation standards of scholarly work in the above mentioned discipline. Components Thesis directed by Prof. Zoya Popovi´c This thesis presents the analysis, design, and measurement of air-filled millimeter-wave rectangular coaxial components microfabricated...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2006